"Angel eye" headlights without removing headlight seal?

[crankcase]

I remember there was quite a lot of discussion/interest around 'angel eye' headlights on the forum a couple of years ago, but it usually involved heating the headlight assembly to remove the rubber seal, and then sealing it back after installing the ring.

 

Is there any way to install without that? Any new developments in this area?

 

It seems like the angel eye look has fallen out of favour lately, but I still prefer it to the newer 'eyebrow' designs

 

Any information or suggestions welcome. Thanks!!

[rabbit1587]

Sure must open the headlight de....

[crankcase]

Ohhh... I am ok to take out the headlight unit from the bike to fix it all up, but don't want to mess with the manufacturer's seal. Scared what will happen if I can't seal back properly and it starts to leak or fog up

[BC]

no point doing it cos not lta-compliant... inspection will definately be an issue...

[rabbit1587]

Don worry sure can seal Nicely de.... So far I do ok just need to put sealant