SBF Silverwings / HOM Cafe 2012

[Uncle]

  Fazli said:

Uncle! How's your DIY change gasket doing? How long you took to do the whole job...

 

Sent from my HTC Sensation XE with Beats Audio Z715e using Tapatalk 2

 

Sibeh Siong! Hiccups here and there, some interesting discoveries and phase 1 completed as planned. Phase 2 continue tmr. Will post some pics when done. I think you better let someone do it

[Uncle]

Side stand disable, done on confusehaha bike today:

 

1. Put bike on main stand

2. Side stand up

3. Take out side stand sensor bolted to side stand hinge

4. Mark the sensor position w/o disturbing it's position, so that you know where's the up position.

5. Pull a cable tie through the sensor hole and tie tightly, preferably at the notch.

6. Pull another cable tie and secure to the frame. Choose somewhere you can access easily, in case you need to inspect.

7. Test and voila!

8. To revert, simply undo everything

 

http://i1065.photobucket.com/albums/u382/raymondsg/Silverwing/Miscellaneous/e8e0abba.jpg

Edited April 27, 2012 by Uncle

[Fusionjaz]

  SW9000 said:

Tomorrow BKT...

 

7.30am, Shell

 

Roger!!!

[Fazli]

  Uncle said:

Side stand disable, done on confusehaha bike today:

 

1. Put bike on main stand

2. Side stand up

3. Take out side stand sensor bolted to side stand hinge

4. Mark the sensor position w/o disturbing it's position, so that you know where's the up position.

5. Pull a cable tie through the sensor hole and tie tightly, preferably at the notch.

6. Pull another cable tie and secure to the frame. Choose somewhere you can access easily, in case you need to inspect.

7. Test and voila!

8. To revert, simply undo everything

 

http://i1065.photobucket.com/albums/u382/raymondsg/Silverwing/Miscellaneous/e8e0abba.jpg

 

I thought there was an easier way by shorting the connector of the switch?

 

Sent from my HTC Sensation XE with Beats Audio Z715e using Tapatalk 2

[confusehaha]

  Fazli said:

I thought there was an easier way by shorting the connector of the switch?

Sent from my HTC Sensation XE with Beats Audio Z715e using Tapatalk 2

Yup, either way also can

this will be a more uncommon method.. no harm trying too!

Edited April 27, 2012 by confusehaha

[Uncle]

  Fazli said:

I thought there was an easier way by shorting the connector of the switch?

 

Sent from my HTC Sensation XE with Beats Audio Z715e using Tapatalk 2

 

Not quite true. To short / close the circuit, you'll need 2 female connectors instead of a paper clip, as they are male pins.

[MaIkEr]

  Fazli said:

I thought there was an easier way by shorting the connector of the switch?

 

Sent from my HTC Sensation XE with Beats Audio Z715e using Tapatalk 2

 

http://img.tapatalk.com/7343c09f-cd57-b43d.jpg

 

idea is to close the circuit, how to is up to our own creativity.

that red connector, which I use to close the circuit, is from autobac. 10mins job.

if you want min disturbance, can buy a separate female connector.15mins.

[skai1605199585]

Hi there.. any recommended shops for respray of sw600..thanks

[Twister6868]

  Uncle said:

It's not just the SWT or GT that are using the newer clutch bell but the US FSC600 also uses the new part from 2010 onwards. For SG, it's SWT / GT from end 2010 onwards since FJS reached end-of-sales.

 

New clutch bell is a design upgrade with thicker materials, so that the resonance sounds produced from the designed clutch slippage while moving off is reduced. Clutch bell usually doesn't wear as it's clutch pad that wears off, again by design.

 

 

Hello to all the experts here ,

 

How about changing to aftermarket clutch + bell (e.g. Dr Pulley Hit Clutch), will it also resolve the "Pigeons" sound?

 

BTW, any significant improvement if change to Dr Pulley Hit Clutch?

 

 

Thanks, have a nice weekend....

[Uncle]

  Twister6868 said:

Hello to all the experts here ,

 

How about changing to aftermarket clutch + bell (e.g. Dr Pulley Hit Clutch), will it also resolve the "Pigeons" sound?

 

BTW, any significant improvement if change to Dr Pulley Hit Clutch?

 

 

Thanks, have a nice weekend....

 

I think nobody has tried HIT clutch on SW; but MaIkEr used it on Burgman. Supposed to engage faster and harder, so less slip. In theory should help but will cost 3x a new clutch bell.

[whyzee]

  s[MENTION=143279 said:

Kai[/MENTION];7568621]Hi there.. any recommended shops for respray of sw600..thanks

 

Go AC Motor. Ah Choong rented a portion of his shop to a paint shop, n that guy does quite a good job, while Ah Choong can dismantle the bike properly.

[hachi]

  whyzee said:

Go AC Motor. Ah Choong rented a portion of his shop to a paint shop, n that guy does quite a good job, while Ah Choong can dismantle the bike properly.

 

I was wondering how much?? Can consider if the price is ok...Feel like spraying to KTM orange...

Edited April 28, 2012 by hachi

[scoobydoo]

disabling the side stand sensor mod was discussed quite some time back...

 

unless you really desire the convenience, this mod is not recommended due to safety pitfalls... Honda added the sensor for safety reasons

 

but... to each their own ba

Edited April 28, 2012 by scoobydoo

[kmkoon]

Hi.. I went to bike shop to check my battery.. The mech say charging no problem, the problem is my battery going to die soon.. Ask me to change new battery..

 

Any advise ? Thanks for help..

[SW9000]

Wooohooo.

 

Back from Bah Kut Teh at Kota Tinggi and then Reborned.

[Fusionjaz]

The BKT at Kota Tinggi tasted marvelous.

 

 

[Fusionjaz]

  kmkoon said:

Hi.. I went to bike shop to check my battery.. The mech say charging no problem, the problem is my battery going to die soon.. Ask me to change new battery..

 

Any advise ? Thanks for help..

 

What advise are you looking for...?

[kmkoon]

  Fusionjaz said:

What advise are you looking for...?

 

Looking for what model battery should look out for?

What is the market price for the battery scare kanna tok..

Swt izzit use the same battery wif old jdm?

Do i need to change battery or just do charging with 14v ar bike shop?

 

Thanks

[kmkoon]

  Fusionjaz said:

What advise are you looking for...?

 

Looking for what model battery should look out for?

What is the market price for the battery scare kanna tok..

Swt izzit use the same battery wif old jdm?

Do i need to change battery or just do charging with 14v ar bike shop?

 

Thanks

[Uncle]

  kmkoon said:

Looking for what model battery should look out for?

What is the market price for the battery scare kanna tok..

Swt izzit use the same battery wif old jdm?

Do i need to change battery or just do charging with 14v ar bike shop?

 

Thanks

 

http://www.singaporebikes.com/forums/showthread.php/325894-lt-Info-gt-Silverwing-400cc-600cc-Tech-Corner?p=4750650&viewfull=1#post4750650

 

$130-$145 for the YTZ-14S. Battery life is about 2-3 years usually.

[hachi]

  Uncle said:

http://www.singaporebikes.com/forums/showthread.php/325894-lt-Info-gt-Silverwing-400cc-600cc-Tech-Corner?p=4750650&viewfull=1#post4750650

 

$130-$145 for the YTZ-14S. Battery life is about 2-3 years usually.

 

Thank you for your help...Just reached home and found coolant reservoir empty..Top up the reservoir with coolant...Somehow got air lock and the coolant drain to the radiator....

Your portable jet spray really power...

Edited April 28, 2012 by hachi

[Fusionjaz]

Reply in blue

 

  kmkoon said:

Looking for what model battery should look out for?

As advise by Uncle.

What is the market price for the battery scare kanna tok..

As advise by Uncle

Swt izzit use the same battery wif old jam?

I am not sure if it is the same as jdm but if you are replacing just make sure you can the correct capacity and correct voltage.

Do i need to change battery or just do charging with 14v ar bike shop?

Replace the battery before the dynamo and rectifier goes defective because of overloading.

 

Thanks

[kmkoon]

  Uncle said:

http://www.singaporebikes.com/forums/showthread.php/325894-lt-Info-gt-Silverwing-400cc-600cc-Tech-Corner?p=4750650&viewfull=1#post4750650

 

$130-$145 for the YTZ-14S. Battery life is about 2-3 years usually.

 

Thanks uncle... Noted..

[kmkoon]

  Uncle said:

http://www.singaporebikes.com/forums/showthread.php/325894-lt-Info-gt-Silverwing-400cc-600cc-Tech-Corner?p=4750650&viewfull=1#post4750650

 

$130-$145 for the YTZ-14S. Battery life is about 2-3 years usually.

 

Thanks uncle... Noted..

[kmkoon]

  Fusionjaz said:

Reply in blue

 

Thanks bro.. Noted..