Suzuki Hayabusa

[romeo_23]

upz for falcon riders...........

[NewOldGuy]

haha u mean bra??

 

its what underneath...

[salem77]

there are chances that the gps connector, white triangle is full of oil now.

clean it up. u shld be ok.

 

any write-up for dat bro ??

[quizesilver]

any write-up for dat bro ??

 

take out rider seat,

use allen key to open the two allen screw on the front of the tank.

use the tank support located at the pillion seat (it is a abt 30+cm long) metal support.

then put the tank support and lift up the tank.

 

the gps connector is located under the tank near to the sprocket area.

the gps connector is white triangle in shape connected to 3 wire wiring.

use lotza of toilet paper or cotton bud to clean up that area.

 

once clean, put down the tank and if u can mount on main stand or bike support, jack up the rear wheel.

 

start the bike

press and hold the gi pro button located below to go into programming mode.

then go thru the programming mode, in setting the gear.

and set it to mode 5 after that.

 

once done, screw back the tank and the rider seat.

 

cheers

[valhallas]

any write-up for dat bro ??

 

bro.. i had the same problem too. guess for our bike of older model the wiring quite haywire. still trying to rectify the prob though. the triangle thing quizesilver mention for mine the connection nt so gd. someone mention abt the grounding here.. perhaps can provide more detail? i haven look into the grounding yet. dat might be causing the error.

[quizesilver]

bro.. i had the same problem too. guess for our bike of older model the wiring quite haywire. still trying to rectify the prob though. the triangle thing quizesilver mention for mine the connection nt so gd. someone mention abt the grounding here.. perhaps can provide more detail? i haven look into the grounding yet. dat might be causing the error.

 

this checking only provide a initial check.

if all is ok.

u have to check the clutch internal small spring which push out the sensor to the gps. that if the spring is loose or "degrade" it would cause wrong read of the gear which the gipro will read it wrongly causing it to jump up n down depending on the problem spring.

[quizesilver]

mark and nok

can i confirm both of you need the hayabusa balancer ?

i need to know the number of set to get a shipping price

[Rebby]

diy stator and rectifier change,

 

assume got stator, stator cover gasket, rectifier, new battery 12series.

know how to remove fairing, battery charger while u are doing the diy.

stator

- remove left fairing

- remove all 9 bolt via size 8 hex spanner

- clean up the gasket using pen knife or anything sharp

- take out the old stator, replace with the new one. almost idiot proof.

- put back the with new gasket.

done

 

rectifier

- remove tail fairing

- rectifier is located on the left side near the signal

- unplug and change.

done

 

relax drink kopi, battery charged, put in new battery, crank it up.

all ok. then put back fairing.

well done.

----------

Clear & systematic explanation by you, Quizesilver.

Makes me wanna return to Singapore to open and do, though i have no problem with it. Missing my Hbusa,

Wish YOU all a great weekend,

rgds

 

ya man... like quizesilver said.. don't any how touch wor.. haha.. you should be back in sg~~ see ya ard.. friday i got wedding dinner to attend maybe later at nite if you guys got meet up~

[Nok97]

mark and nok

can i confirm both of you need the hayabusa balancer ?

i need to know the number of set to get a shipping price

 

I had mine fabricated locally...

[quizesilver]

I had mine fabricated locally...

 

still can fab 2 more set of 500g ea balancer ?

[Nok97]

still can fab 2 more set of 500g ea balancer ?

u want i pass u the Tel no. u check it out ..

Cheers!

[quizesilver]

u want i pass u the Tel no. u check it out ..

Cheers!

 

okie!

thanks

[salem77]

take out rider seat,

use allen key to open the two allen screw on the front of the tank.

use the tank support located at the pillion seat (it is a abt 30+cm long) metal support.

then put the tank support and lift up the tank.

 

the gps connector is located under the tank near to the sprocket area.

the gps connector is white triangle in shape connected to 3 wire wiring.

use lotza of toilet paper or cotton bud to clean up that area.

 

once clean, put down the tank and if u can mount on main stand or bike support, jack up the rear wheel.

 

start the bike

press and hold the gi pro button located below to go into programming mode.

then go thru the programming mode, in setting the gear.

and set it to mode 5 after that.

 

once done, screw back the tank and the rider seat.

 

cheers

 

thnz dude, will do it dis weekend

 

bro.. i had the same problem too. guess for our bike of older model the wiring quite haywire. still trying to rectify the prob though. the triangle thing quizesilver mention for mine the connection nt so gd. someone mention abt the grounding here.. perhaps can provide more detail? i haven look into the grounding yet. dat might be causing the error.

 

well im thinking of getting a used set of wire harness from ebay wo any cuts

 

or splices to replace the haywired harness btw hw uve been lately ??

[salem77]

any falcons riding-up for sepang motoGp09 ???

[valhallas]

well im thinking of getting a used set of wire harness from ebay wo any cuts

 

or splices to replace the haywired harness btw hw uve been lately ??

 

if im nt wrong, the harness cost abt 300 to 400 plus. a bit ex so i juz gonna live wif it. seldom riding it but wen i do.. always a thrill. doin fine nw bro.. thanks for asking.

btw, some guy approached me sayin he was the previous busa owner. finally met the guy after 3 yrs coz was lookin for him to learn more abt the bike history. had a nice chat wif the guy n apparently learned that albert motors screwed us similarly on the deal. wats past is past n my busa healthy nw.

bro.. do update me ya if you gonna buy the harness. if gt sometin nice maybe i might share shipping costs wif u. n abt the gipro.. update me oso if uve manage to resolve the issue. thanks..

[valhallas]

this checking only provide a initial check.

if all is ok.

u have to check the clutch internal small spring which push out the sensor to the gps. that if the spring is loose or "degrade" it would cause wrong read of the gear which the gipro will read it wrongly causing it to jump up n down depending on the problem spring.

 

ok.. will do check bro.. thanks!

[Nok97]

okie!

thanks

 

Done.. PM u the tel N add

[salem77]

 

if im nt wrong, the harness cost abt 300 to 400 plus. a bit ex so i juz gonna live wif it. seldom riding it but wen i do.. always a thrill. doin fine nw bro.. thanks for asking.

btw, some guy approached me sayin he was the previous busa owner. finally met the guy after 3 yrs coz was lookin for him to learn more abt the bike history. had a nice chat wif the guy n apparently learned that albert motors screwed us similarly on the deal. wats past is past n my busa healthy nw.

bro.. do update me ya if you gonna buy the harness. if gt sometin nice maybe i might share shipping costs wif u. n abt the gipro.. update me oso if uve manage to resolve the issue. thanks..

 

sure will bro, tkc

[carbine]

any falcons riding-up for sepang motoGp09 ???

 

i thinking of riding up for the race only.......as fri & sat i gotta work...

[alifk69]

hi bros.. anyone selling white tankbra for haya '00? pls pm me..

also looking for akra, yoshi or two bros pipe...

[salem77]

arbine;5895087']i thinking of riding up for the race only.......as fri & sat i gotta work...

 

u'll be riding-up sun morning ????

[salem77]

F I N A L L Y......

 

welcome to page 9-3-7

[carbine]

u'll be riding-up sun morning ????

 

i suppose so...before daybreak...

[-PiE-]

anyone have this problem b4? i can't seem to cruise @ 15km/h - 25km/h smoothly. u noe, when u moving around car parks.. my bike will feel like it's jerking. like wan to stall tt type of feeling..

[pinetreetmh]

anyone have this problem b4? i can't seem to cruise @ 15km/h - 25km/h smoothly. u noe, when u moving around car parks.. my bike will feel like it's jerking. like wan to stall tt type of feeling..

 

at that speed u need to half clutch ..