-=BabyBlade=-(CBR)

[kianleong]

wah has being yrs since i ride to jb lolz

[vin82]

ninja's it ok. i back out. anyway juz brought a voltmeter also. tks a lot

 

ok, collected d 3 pieces shadow voltmeter..

Ninjalite

2.gladiator

3. lsoul

4.wongwz84

5.vin82

 

so far, me n lsoul confirmed.last piece who among u 3 will take?? Glad,wong or vin82? $28...

[NinjaLite]

hmmm ya..ride Wave for daily transport..den mod our fireblade n layup for track use oni..

 

imagine PG can keep 32 fireblades ther or not?? every wk we ride 32 Wave go PG n change back to fireblades for track session

[NinjaLite]

KL, den u must reali go jb.. bring u to AGL...eye-opener ah... better den Changi V

[ICE87]

Ice, do let us kw if u plan to change any acce/stuff...

 

we got MO open for Power Abuser2 and also hi temp radiator hoses..also open to Mod d fairin in JB though no one can spare their bike to put in JB for 2 weeks so far...

 

other things before u do servicing or repair can check wif us....

 

 

ok bro...thanks for the heads up...but i tink i will onli top up petrol at jb ah...service or repair bike tink i stick in spore...dowan to put bike in jb for so long ah...haha...bro got qn to ask...:

 

1)small crack or a bit broken fairing hw much to repair...?

2)spray 1 colour for rims front and rear tyre hw much...?

3)spray rear mudguard and some small tings hw much ah...?

which shop best to go for price...?

 

thanks...

[NinjaLite]

spray depends la ,must ask from shops.. but rims spray $80 using can..powder spray $160..quoted from hkl and Knt..

 

most bikeshops outsource to sprayshops so hard to say..

 

but First Motor said 2 b gud ..but u must for higher price..

[gladiat0r]

ICE87:just a suggestion bro, IF you getting a new bike it would be wiser to spend money on the inside of the bike rather than e outlook first..when u buy a bike first thing to look out for is batt and rectifier,,,you have to change this both..unless you have cash to spend on outlook and inside then ok la but just an advice.cos no point having the best paint job and outlook when it cant run and start properly..

[gladiat0r]

hmmm ya..ride Wave for daily transport..den mod our fireblade n layup for track use oni..

 

imagine PG can keep 32 fireblades ther or not?? every wk we ride 32 Wave go PG n change back to fireblades for track session

 

POWER!!!!!!!!!!!!

[ICE87]

ICE87:just a suggestion bro, IF you getting a new bike it would be wiser to spend money on the inside of the bike rather than e outlook first..when u buy a bike first thing to look out for is batt and rectifier,,,you have to change this both..unless you have cash to spend on outlook and inside then ok la but just an advice.cos no point having the best paint job and outlook when it cant run and start properly..

 

oh...good advice bro...thanks thanks...i'll ask the owner hw long he has used the batt and rectifier...thanks you for ur advice bro...any other tings i need to take note of...?i dun really noe abt the inside of bikes ah...so i'll need ur advice...haha...i will do servicing for the bike once i receive it tho....

[yazid]

ninja and yazid- looks like we got one more shop to blacklist already...anyway thumbs up to equipment extreme...really wanna do the pa and grounding there...the guy was so nice and patient to explain stuff to us..he really know his stuff, unlike someone from another shop...upss for equipment extreme..

 

yeap im definitely gng back to equipment exreme. yesterday when u go off already i went back n chat with him till ard 5pm sia. really learnt alot from elson n he told me the problem with my bike. ur right he sure knows his stuff:thumb:

 

at shop respray rims $80 using can.. powder spray abt $160..2 days

 

wah so ex:faint: i want to respray myself but i need someone to teach me how to take out n put back rims.

[daydream]

anyone here knows cbr 400 repair which shop is good at ??

[gladiat0r]

oh...good advice bro...thanks thanks...i'll ask the owner hw long he has used the batt and rectifier...thanks you for ur advice bro...any other tings i need to take note of...?i dun really noe abt the inside of bikes ah...so i'll need ur advice...haha...i will do servicing for the bike once i receive it tho....

 

here's a list of what i'll suggest you do first,i did the same things-

-wash tune carbs

-change EO and filter

-batt and rec

-brake pads and brake fluid

-check sprockets and chain

-tyres

-cone bearings,wheel bearings

-clutch cable,throttle cable

-wash and flush coolant

-change coolant hoses

-air filter

 

the above mentioned is just a guide of things recommended to get done first,as our other fellow bladers know,this all is considered the minor things that need to be done.the MAJOR things would be suspension, wiring and so on..hope this helps.cheers bro!

[gladiat0r]

anyone here knows cbr 400 repair which shop is good at ??

 

we are all searching for a gd shop too,not really sure of where you should go to BUT i can tell you where you SHOULD NOT go to...ha..but seriously you can try unique motorsports,few of the bladers say they're gd..personally i'm gonna pay a visit to bikelab and 1 racing performance next..

[Aalex82]

ya..dats one problem..conflictin view... but den even different shops also got different opinion...1 good example 2day is d velocity stack for our fireblades..

some say short better , some say long...

 

 

must see wat is the purpose of the bike..

if u need to mid range to improve, use the shorts one.

if u need better pick-up, use long one is better..

that y diff shop give diff views..

[gladiat0r]

must see wat is the purpose of the bike..

if u need to mid range to improve, use the shorts one.

if u need better pick-up, use long one is better..

that y diff shop give diff views..

 

aalex82,can u define the term mid range?

[Aalex82]

aalex82,can u define the term mid range?

 

abt 5k to 8k..

[gladiat0r]

ah ok...thanks..

[ICE87]

here's a list of what i'll suggest you do first,i did the same things-

-wash tune carbs

-change EO and filter

-batt and rec

-brake pads and brake fluid

-check sprockets and chain

-tyres

-cone bearings,wheel bearings

-clutch cable,throttle cable

-wash and flush coolant

-change coolant hoses

-air filter

 

the above mentioned is just a guide of things recommended to get done first,as our other fellow bladers know,this all is considered the minor things that need to be done.the MAJOR things would be suspension, wiring and so on..hope this helps.cheers bro!

 

 

wah...so many tings ah bro...thanks thanks....

[745]

haha, today my bike made me feel happy at the same time abit sad only la.

today played with another babyblade, seems like he did had a hard time to catch up, my exit near already so slowed down... but after he zoom past me before i reach the exit i tryto catch up but cant... my bike not elite bike ley... haha ofcouse it is not since i din mod it like glad or wong did. but still happy lah for keeping the game longer ,....heheh, any way if the orange bald is reading tis, no offence bro, only fun.

location- AYE along near by jalan amhad ibrahim on the left at 9.40 pm

[vin82]

lol...that's fierce........

 

 

hmmm ya..ride Wave for daily transport..den mod our fireblade n layup for track use oni..

 

imagine PG can keep 32 fireblades ther or not?? every wk we ride 32 Wave go PG n change back to fireblades for track session

[745]

ICE87:just a suggestion bro, IF you getting a new bike it would be wiser to spend money on the inside of the bike rather than e outlook first..when u buy a bike first thing to look out for is batt and rectifier,,,you have to change this both..unless you have cash to spend on outlook and inside then ok la but just an advice.cos no point having the best paint job and outlook when it cant run and start properly..

 

 

 

what you say is exacly rite gladiator, tis is a common mistake most of ppl make. they see the prop and change it. the inner part of the bikes are the important things which cant be easily seen. and further more , bike ugly also nvm. the health of it not good can, .... will even some time have to end up park the bike at the side of the road and take taxi to work. haiz.. kenna before on my SP.

 

so gald whats the next mod you planning to do? the grounding and PA is it?

tell me when you going ok, will inform you if i can tag along(same to ninja)

[yazid]

ya gladiator doing pa2 with me. i want to get it done asap so when u guys free msg me ah.

[gladiat0r]

what you say is exacly rite gladiator, tis is a common mistake most of ppl make. they see the prop and change it. the inner part of the bikes are the important things which cant be easily seen. and further more , bike ugly also nvm. the health of it not good can, .... will even some time have to end up park the bike at the side of the road and take taxi to work. haiz.. kenna before on my SP.

 

so gald whats the next mod you planning to do? the grounding and PA is it?

tell me when you going ok, will inform you if i can tag along(same to ninja)

 

hey bro..hows life man...?yup next for me would be grounding and pa..tyres finishing real soon too...i'll be going with yazid to do the grounding and pa.do join us,i'll confirm with yazid and let you know when..im also planning a visit to 1 racing performance...its a shop recommended by a track regular who also rides cbr..gonna do full servicing there.

[kianleong]

KL, den u must reali go jb.. bring u to AGL...eye-opener ah... better den Changi V

 

haha i think my 2b yrs 1 week i 2 days will be in agl LOL!

[Addictive]

hi people, i'm a new fireblade owner. I wish to know where is the authorised part dealer in singapore? isit FJT or anywhere, pls do let me know. =) Need to purchase some minor spare parts and fix on my own.

Thks and have a nice day everyone.