SBF Silverwings Cafe 2008 - JDM/Euro 400/600

[Sensible]

Yes maybe it is your plugs - check the gap carefully and make sure you tighten them correctly but not too tight. The trick is to put a little high melting point grease on the threads of the plugs and tighten. Then again if you are using lower octane fuel (92 or 95) might be better for high speed to go to 97 or 98. Also dont mess with the idling speed adjustment - even 1400rpm is ok. Last but not least the standard Air Filter is a bit restrictive - perhaps you try the K&N.

My 2006 SW400 (reg Nov 07) could reach 170 no problem - but no Breadbox behind and rear suspension MUST be set harder. As for the plugs go for Nippon Denso Iridium (model Number IUH 24).

 

The throttle control they are talking about refers to opening TOO full throttle to fast - open gradually and back off slightly when nearing max RPM then open again - never just hold the throttle against the STOP - it actually is a smaller opening than at say 95% open - for full throttle operation You would need to make sure that the cable is adjusted right and butterfly valve exactly horizontal at max opening.

 

Thanks for the very comprehensive reply, bro Kris!

 

Will change to Denso spark plugs soon!

 

Setting suspension to HARD means changing to a higher suspension setting number is it??

 

Does fixing K&N filter means more fuel-consumption during normal days ride?

[contacted]

Happy new year to all the SWingers and future SWingers to be... WOO HOO... Zero accidents!! Ride safe....

[fraggershell]

http://www.singaporebikes.com/forums/showthread.php?t=172413

 

 

hi guys, as mention above to the thread. i am wonder if i trade in my bike for a silverwing, in this case most likely is a second hand. am i in for saving or a lost? which year of production is good and how much? thanks dude

[Aqis]

Happy New Year To All!!!

[merz65]

i can't find any sec hand Swing, so guess i'm tradng in mine for a first hand... any1 can tell me how much Litres of EO n plugs needed per servcing? total fuel is 16L ? with 3.5L reserve inside?

[recko]

i can't find any sec hand Swing, so guess i'm tradng in mine for a first hand... any1 can tell me how much Litres of EO n plugs needed per servcing? total fuel is 16L ? with 3.5L reserve inside?

 

You can gather some info over here first:

Silverwing 400cc / 600cc Tech Corner

[bigcow]

how you control??

you fully open arleady speed 170.

you close abit speed drop then open again also 170??

 

tell u more the next time i see u. scooter behavior is very wierd one. not say u full blast one shot and tats your top speed. sometimes u got to close a little.

[bigcow]

Thanks for the very comprehensive reply, bro Kris!

 

Will change to Denso spark plugs soon!

 

Setting suspension to HARD means changing to a higher suspension setting number is it??

 

Does fixing K&N filter means more fuel-consumption during normal days ride?

 

but always remember. setting the rear suspension too hard will allow u to go faster. cos when u blast, there is lesser sag. bot not forgetting if set too hard, your frt and rear suspensions are not balance. so during the wet, your front will feel very light and the tire grips won't be as good.

[HelmetBOX1605198525]

http://www.singaporebikes.com/forums/showthread.php?t=172413

 

 

hi guys, as mention above to the thread. i am wonder if i trade in my bike for a silverwing, in this case most likely is a second hand. am i in for saving or a lost? which year of production is good and how much? thanks dude

 

i can't find any sec hand Swing, so guess i'm tradng in mine for a first hand... any1 can tell me how much Litres of EO n plugs needed per servcing? total fuel is 16L ? with 3.5L reserve inside?

 

there is two used silverwing at lousis hope this help...

it blue in colour..

if i rememeber correctly if FY plate..

price i believe it 7.5k to 8.5k..

[bigcow]

there is two used silverwing at lousis hope this help...

it blue in colour..

if i rememeber correctly if FY plate..

price i believe it 7.5k to 8.5k..

 

JDM for 7.5 to 8.5k too ex lo. my friend got his for only 5k+

[merz65]

there is two used silverwing at lousis hope this help...

it blue in colour..

if i rememeber correctly if FY plate..

price i believe it 7.5k to 8.5k..

 

realli? at where is e place? kakit bukit ? when u seem it? looI'S MOTOR huh.

i went ard mid dec.. didn't see any sec hand SW lei..

[recko]

JDM for 7.5 to 8.5k too ex lo. my friend got his for only 5k+

That one kio tio one...

[rayhunter]

That one kio tio one...

 

kio tio from private seller or shop??

[recko]

kio tio from private seller or shop??

Dun wanna say

[fraggershell]

hmmm wad's the diff between euro and jdm model ar? wad to look out for when buying one?

[bigcow]

hmmm wad's the diff between euro and jdm model ar? wad to look out for when buying one?

 

this has been posted b4. pls read up the previous posts

[recko]

hmmm wad's the diff between euro and jdm model ar? wad to look out for when buying one?

See page 43, post 2134...

[bigcow]

kio tio from private seller or shop??

 

got a few friends who got this deal le. not only 1. mostly through private owner.

[rayhunter]

got a few friends who got this deal le. not only 1. mostly through private owner.

 

oic...shop selling confirmed more expensive than private seller..

[h_LoNg]

I bought mine from private seller also...

 

Quite a kio tio deal also...

 

Anyway Happy New Year to all riders...

 

May u have a prosperous and fruitful year ahead

[Maos Adventure]

oic...shop selling confirmed more expensive than private seller..

 

cause bikeshop sure need to earn & seller need to get rid of it asap.

[2strokia]

any bros can help give advise? looking for brand new SW400 euro model 2008. which shop do u recommend and price, so far been to speedway, Looi's and Mah, they quote $12K+ to 13K+ OTR with 6mths rd tax & 2nd party ins 4-5% interest per year. Also not sure if it is a 2007 or 2008 model?

 

can any Bros recommend any shops to buy brand new SW400 euro model 2008? thank you in advance maybe those who recently bought can share here or PM me your OTR price and shop please, thank you big big

[duracellb]

any bros can help give advise? looking for brand new SW400 euro model 2008. which shop do u recommend and price, so far been to speedway, Looi's and Mah, they quote $12K+ to 13K+ OTR with 6mths rd tax & 2nd party ins 4-5% interest per year. Also not sure if it is a 2007 or 2008 model?

 

can any Bros recommend any shops to buy brand new SW400 euro model 2008? thank you in advance maybe those who recently bought can share here or PM me your OTR price and shop please, thank you big big

 

hi 2strokia, you can also check out bike production at serangoon rd. should be the cheapest. but make sure you ask otr price clearly to include all the things (Boon siew or PI bike, the right type of insurance, IU cost, loan agreement cost...etc).

 

i bought from Looi's. Happy to buy from them, though they might not be the cheapest. Old customer of them lah.

 

happy riding. i'm still enjoying my silverwing after 1yr+.

[HelmetBOX1605198525]

any bros can help give advise? looking for brand new SW400 euro model 2008. which shop do u recommend and price, so far been to speedway, Looi's and Mah, they quote $12K+ to 13K+ OTR with 6mths rd tax & 2nd party ins 4-5% interest per year. Also not sure if it is a 2007 or 2008 model?

 

can any Bros recommend any shops to buy brand new SW400 euro model 2008? thank you in advance maybe those who recently bought can share here or PM me your OTR price and shop please, thank you big big

 

speedway very good...

use to get my R6 from them..

when getting my new SW..

the charge me a early settelement.... very reasonable price of 800..

[h_LoNg]

speedway very good...

use to get my R6 from them..

when getting my new SW..

the charge me a early settelement.... very reasonable price of 800..

 

R u joking or wat?

U got ur New SW from the same shop and they still charge u $800 early settlement charge?