[Group] YAMAHA Fazer

[Constructicon]

-Found the problem of the sound came from my mirror LOL....... no wonder keep tick tick tick tick

-the clutch thing is normal is i think too much

 

Normally how much you guys pump for ur fz1n tire any recommend.

anyone changed ignition coil plug cap before under what condition then must change ah?

they said change 1 need 130 total need to change 4 of them

 

Its utter BS to change all 4 coils at once.

The price as stated in one of the replies is about $110.

The coils on my FZ1, I have changed 1 at 40,000km, and another one at 60,000km. The other 2 are still stock. My bike mileage from new is 70,000km liao.

 

When the coil start to fail, its very noticeable. At idle, the RPM will not be stable and will jump/ hiccup at idling. If your idle is set to 1000, it will hover at 900-1000 with a very noticeable sound with a very rough edge about it.

And at low speed, you can feel that the bike is dragging since one of the cylinders is not firing properly.

At higher speed/ RPM, it less noticeable although there is a distinct jerkiness about the engine.

[hilfiger]

Its utter BS to change all 4 coils at once.

The price as stated in one of the replies is about $110.

The coils on my FZ1, I have changed 1 at 40,000km, and another one at 60,000km. The other 2 are still stock. My bike mileage from new is 70,000km liao.

 

When the coil start to fail, its very noticeable. At idle, the RPM will not be stable and will jump/ hiccup at idling. If your idle is set to 1000, it will hover at 900-1000 with a very noticeable sound with a very rough edge about it.

And at low speed, you can feel that the bike is dragging since one of the cylinders is not firing properly.

At higher speed/ RPM, it less noticeable although there is a distinct jerkiness about the engine.

 

Good info!

[pichudot]

Just changed to PR3 tires 2 hours ago at $400. I guess this is the cheapest deal so far.

 

mind sharing where u got it from? and size of tires?

[pichudot]

Hi fellow FZ1 riders,

 

Can you guys advice where can i get the LED pod/ pilot lights for my FZ1S?

Any idea if there are shops around Ubi that sell these stuff? I usually go Planet for servicing, so it will be convenient if I can get the LEDs there.

 

Thanks!

 

around Planet, u can try autobacs but expensive, or motoWorld (50-50), or the shops along the stretch with Planet..

 

last but not least, give a short ride down to auntie shop, 100% sure got, affordable as well.. lol..

 

or if u like, check the MO section out for some sellers there..

[swat_]

Planet also selling PR3 for 400.. For set with rear 180/55..

 

Sent from my GT-N7000 using Tapatalk 2

[sICkbOi-dOt-cOm]

Do u off engine when the fan is still on? Or wait till fan off den switch off engine?? Coz i tried waiting for the fan to cut off but wait wait wait till the cows go home..

 

Sent from my GT-I9300 using Tapatalk 2

[slayerxx]

Its utter BS to change all 4 coils at once.

The price as stated in one of the replies is about $110.

The coils on my FZ1, I have changed 1 at 40,000km, and another one at 60,000km. The other 2 are still stock. My bike mileage from new is 70,000km liao.

 

When the coil start to fail, its very noticeable. At idle, the RPM will not be stable and will jump/ hiccup at idling. If your idle is set to 1000, it will hover at 900-1000 with a very noticeable sound with a very rough edge about it.

And at low speed, you can feel that the bike is dragging since one of the cylinders is not firing properly.

At higher speed/ RPM, it less noticeable although there is a distinct jerkiness about the engine.

 

Hey thanks for sharing... But how i know which wan spolit are there any way to check? And where did you change at?

Just took over the bike still pending to change coz bike really unsteady at low rpm can feel cannot fire properly.

[Yatz86]

Do u off engine when the fan is still on? Or wait till fan off den switch off engine?? Coz i tried waiting for the fan to cut off but wait wait wait till the cows go home..

 

Sent from my GT-I9300 using Tapatalk 2

 

Off engine when fan is on/off when stopping.

 

No need to wait Ure temp to go down.

 

Since Ure already parking just let it air cool.

 

And it's wasting battery.

[joseph ong]

mind sharing where u got it from? and size of tires?

 

I got it at planet. Size 180 55 17 for rear. This size still got stock but limited, the other sizes seems like sold out but no harm asking.

[Constructicon]

around Planet, u can try autobacs but expensive, or motoWorld (50-50), or the shops along the stretch with Planet..

 

last but not least, give a short ride down to auntie shop, 100% sure got, affordable as well.. lol..

 

or if u like, check the MO section out for some sellers there..

 

Thanks for the info!

I replaced the stock bulbs with blue LEDs from day 1.

3 years + and 70,000km later they are still working , just a bit dimmer.

[Constructicon]

Hey thanks for sharing... But how i know which wan spolit are there any way to check? And where did you change at?

Just took over the bike still pending to change coz bike really unsteady at low rpm can feel cannot fire properly.

 

Hi bro, when one of the coils fails, the symptoms is just as I described in the earlier post.

Chances are that at the failed coil, the exhaust header will not be running as hot as other 3 cylinders. So spray some water onto the cylinders and see. At least that's what I saw them do at Planet.

Else, there's always a case of trial and error. haha

 

U have changed the cheapest and necessary stuff already? Oil filter, air filter, engine oil, plugs....etc?

[pichudot]

I got it at planet. Size 180 55 17 for rear. This size still got stock but limited, the other sizes seems like sold out but no harm asking.

 

thanks for the info!

 

looks like nowadays fz1 riders loves 180/55? yours fz1 too?

 

i once changed to 190/55 and i'm stuck to loving it.. o man~

[pichudot]

Thanks for the info!

I replaced the stock bulbs with blue LEDs from day 1.

3 years + and 70,000km later they are still working , just a bit dimmer.

 

oh? maybe u can go back to the same shop u bought at day 1?

 

yours considered very good already.. most pole light LEDs i seen around only last for a few months to a year or something..

[adrielneo]

oh? maybe u can go back to the same shop u bought at day 1?

 

yours considered very good already.. most pole light LEDs i seen around only last for a few months to a year or something..

 

my pole light... i buy from g market hahahahahaha no time to go limbatt

[RAKz]

Guys. came across Hong Leong website and realized now some of the Yamaha bikes come with free Akra exhaust? Anyone bought new bikes recently that can confirm these?

 

http://www.hlcorp.com.sg/motorcycles/catalogue.asp

[stRobe]

Guys. came across Hong Leong website and realized now some of the Yamaha bikes come with free Akra exhaust? Anyone bought new bikes recently that can confirm these?

 

http://www.hlcorp.com.sg/motorcycles/catalogue.asp

 

Yes, its true. Fazer 8N/S and R6 comes with free akra.

Based on their price list for March.

[slayerxx]

Hi bro, when one of the coils fails, the symptoms is just as I described in the earlier post.

Chances are that at the failed coil, the exhaust header will not be running as hot as other 3 cylinders. So spray some water onto the cylinders and see. At least that's what I saw them do at Planet.

Else, there's always a case of trial and error. haha

 

U have changed the cheapest and necessary stuff already? Oil filter, air filter, engine oil, plugs....etc?

 

Hey thanks man learned a lot from u didn't know coil no need 1 shot changed all.. My RPM is not stable and will jump/ hiccup at idling just like you said.

Ya i have changed the cheapest and necessary stuff already? Oil filter, air filter, engine oil, plugs....etc

[aliboy]

Hi,

 

Am riding fazer 1000 (2002). Where can I buy wind shield?

[sICkbOi-dOt-cOm]

Hey thanks man learned a lot from u didn't know coil no need 1 shot changed all.. My RPM is not stable and will jump/ hiccup at idling just like you said.

Ya i have changed the cheapest and necessary stuff already? Oil filter, air filter, engine oil, plugs....etc

 

Go planet and get it change. They will spray2 to know which one is faulty.. "normally" the most to the left onee is the culprit..

 

Sent from my GT-I9300 using Tapatalk 2

[joseph ong]

thanks for the info!

 

looks like nowadays fz1 riders loves 180/55? yours fz1 too?

 

i once changed to 190/55 and i'm stuck to loving it.. o man~

 

Me riding FZ6 bro. I cannot resist the power, so better keep my distance from 1000cc bikes. The last time i rode CBR 954, I achieved 328km/hr.

[slayerxx]

Have them checked on the coils and they really spray water to detect which one spolit. And replaced only 1 for me now my bike is so smooth now

 

Hey do you guys experience when riding on road u will feel bumpy in front?

Or bike heavy so it's normal? My weight is 90+ the bike is heavier so bumpy is normal? or do i need to adjust the suspension in front?

Last time i riding super 4 feel like more smoother sia maybe super4 lighter my weight heavier so more stabler?

Just got my fz1n so ask alot ;X

[adrielneo]

thanks for the info!

 

looks like nowadays fz1 riders loves 180/55? yours fz1 too?

 

i once changed to 190/55 and i'm stuck to loving it.. o man~

 

i also using 190/55 cause of you and i love it haha

[KS Kang]

Hi any fellow riders able to help ?? Would like to know what is the fuel consumption for FZ8N and the mthly maintenance how many EO and Plug ?

[danielling1981]

Hi any fellow riders able to help ?? Would like to know what is the fuel consumption for FZ8N and the mthly maintenance how many EO and Plug ?

 

I think most 4 stroke 400cc+ bike is e same. 3+ eo without oil filter. 3+ to 4 eo with oil filter.

 

For FC really depends on e rider. My fz1-s can go up to 19km/l. Our dear master is below 14km/l?

 

Oh and plug = 4

[KS Kang]

Alright !! Thanks man !! Still deciding which bike to get Fz8N or Fz1N . . .