[Group] YAMAHA Rx, Rx-S & Rx-K

[treyhatsu]

yeah man bike is running already.. bros meet up leh sibei sian

[Cpt.ZR]

Hahaha thanks bros for yr help.. Its the bolt that is holding the joint and the exhaust, its not tight enough.. i sprayed some lub and tightened it.. now its gone!

 

 

for the time being.. lol and guys.. rmb to wash yr air filter part regularly... I got bored today and opend up the side covers of my bike... found the air intake... and it was like a mud/grease/dust fest in it.. i sprayed degreaser and scrubbed it for 30 mins... now its clean! the pick up has a slight change [abit faster]! maybe u guys shld clean it up too! not forgetting lub all the chains, joints and movable parts!

 

rmb! rainy season ! Lao K tend to get some chill and reluctant to start lol so take good care of it!

[treyhatsu]

haha very good advise brother..

[logen1836]

Hahaha thanks bros for yr help.. Its the bolt that is holding the joint and the exhaust, its not tight enough.. i sprayed some lub and tightened it.. now its gone!

 

 

for the time being.. lol and guys.. rmb to wash yr air filter part regularly... I got bored today and opend up the side covers of my bike... found the air intake... and it was like a mud/grease/dust fest in it.. i sprayed degreaser and scrubbed it for 30 mins... now its clean! the pick up has a slight change [abit faster]! maybe u guys shld clean it up too! not forgetting lub all the chains, joints and movable parts!

 

rmb! rainy season ! Lao K tend to get some chill and reluctant to start lol so take good care of it!

 

thanks for e advise bro!

[logen1836]

Stuffs Done on Friday (29 Aug 08)

Rewiring of 6V

New Signal Condenser

New Coil

New Rectifier

New Signal Switch

New Rear Brake Shoe

Labour Fee

Total Cost is $185.00

 

and some other stuffs related to the wiring.cant remember all!

[logen1836]

possible to fit the old rxz bellypan for our bikes?

[jasonyeo123]

yeah man bike is running already.. bros meet up leh sibei sian

 

haha everytime i post meet up no one replys to me =/

[jasonyeo123]

Chassis is the main "bone" of the bike.

 

I was looking at one K that has a square silver box (for my upcoming S) - but v v v v ex. Cost about $500. The one that desert scramblers like to install.

 

wad brand izzit ? any pics for me to view?? might install wif u if it look good =)

[Lord Bear]

Anyone care for kopi tonite? Msg me at 81516721. i hope got good respone. Dun worry, kopi will be very late.

[lucifire]

regarding inspection.. i'm sure some of u guys have problems passing it due to the white smoke emmision.. any ideas of how to pass it.. or which shop sends it for cheap price

[Cpt.ZR]

Stuffs Done on Friday (29 Aug 08)

Rewiring of 6V

New Signal Condenser

New Coil

New Rectifier

New Signal Switch

New Rear Brake Shoe

Labour Fee

Total Cost is $185.00

 

and some other stuffs related to the wiring.cant remember all!

 

 

 

EEhh!! where you do man that price is reasonable! Whats the shop? and where at? but the thing is i wanna do but i usually go hua chin.. duno able to trust others or not leh.. cos i somehow trust the hua chin guy leh...

[lucifire]

regarding inspection.. i'm sure some of u guys have problems passing it due to the white smoke emmision.. any ideas of how to pass it.. or which shop sends it for cheap price

[jasonyeo123]

regarding inspection.. i'm sure some of u guys have problems passing it due to the white smoke emmision.. any ideas of how to pass it.. or which shop sends it for cheap price

 

erm for me i go to a shop in bukit merah pay them around 50+ for inspection and the towing charge..... =) dun worry they help u check be4 sending for inspection so sure pass.

[Lord Bear]

If your bike emits lots of white smoke, remove the tubing for the 2T pump connecting to the carburator. Do this only when u are outside the Inspection Center. Remove the tubing, rev your throttle a bit until u see no or little white smoke emission. After yr inspection, dun 4get to connect the tubing back again. Or u can go to yr motorshop ask adjust the 2T pump. Too much 2T emit lots of smoke. NEA 'saman'. Less 2T, piston jam.

[logen1836]

EEhh!! where you do man that price is reasonable! Whats the shop? and where at? but the thing is i wanna do but i usually go hua chin.. duno able to trust others or not leh.. cos i somehow trust the hua chin guy leh...

 

At KNT in Ubi. Along First Motor..

im satisfied wid his workmanship!

mite do a paintwork as well..

gotta check on my budget 1st!

[treyhatsu]

what makes the cdi always foul anyone know ?

[mb2636]

Hi does any1 has a RXK manual..If do, can send me the link...May i know wher u guys do repair your RXK nay bike shop tho recommend...How is the fuel consumption like...if wan to restored wher to send to...sorry asked so many question...

[y2kredbull]

Selling my RXS.Check it out over at Garage sales.

 

http://www.singaporebikes.com/forums/showthread.php?t=204756

[jasonyeo123]

Hi does any1 has a RXK manual..If do, can send me the link...May i know wher u guys do repair your RXK nay bike shop tho recommend...How is the fuel consumption like...if wan to restored wher to send to...sorry asked so many question...

 

u just bought ur bike ?? can meet up wif bear and the rest they usually have gathering can tok more about ur rxk.. thou it's a small group =)

[tijanmr]

Selling my RXS.Check it out over at Garage sales.

 

http://www.singaporebikes.com/forums/showthread.php?t=204756

 

 

 

bro.... asal nak jual????!!!! apa lah......!!!!

[jasonyeo123]

selling rxk seat !! used 1 month already =)

[treyhatsu]

anyone selling tank anoot cheap cheap

[mb2636]

hi..i jus bought a rxk for $500 bucks and looking @ the condition i bet ders lot to be done cos i bought it all stock,all rust...well i hope someone here can help me transform from Lau K to Cafe style british bike...ha ha...well my no. is 94570054...mayb we can have a little chit chat so i can learn from u guys...i saw the threat on where to get the parts(Kelantan Lane)..well any shop u can recommend for me to rebuild....or repair...

[tijanmr]

hi..i jus bought a rxk for $500 bucks and looking @ the condition i bet ders lot to be done cos i bought it all stock,all rust...well i hope someone here can help me transform from Lau K to Cafe style british bike...ha ha...well my no. is 94570054...mayb we can have a little chit chat so i can learn from u guys...i saw the threat on where to get the parts(Kelantan Lane)..well any shop u can recommend for me to rebuild....or repair...

 

 

 

bro, u might want to go to ahm performance at eunos ave 4. there's this malay guy doing up his rxk to a cafe style.... harley tank, sparkling red frame and lots of chrome.... currently, the mech is slowly fixing up the bike..... i assume it will be very chio!!!!! the guy will be collecting on friday... rush down there to take a look. blk 1063, eunos ave 4.

[tijanmr]

hi..i jus bought a rxk for $500 bucks and looking @ the condition i bet ders lot to be done cos i bought it all stock,all rust...well i hope someone here can help me transform from Lau K to Cafe style british bike...ha ha...well my no. is 94570054...mayb we can have a little chit chat so i can learn from u guys...i saw the threat on where to get the parts(Kelantan Lane)..well any shop u can recommend for me to rebuild....or repair...

 

 

 

bro, i and y2kredbull always go to ahm to do our rxk with ah cui..... the apek mech.... old bird who know well on old bikes.... he's riding rxs and his bike can beat any of our bikes here.... so his experience is very useful to us..... no harm going there to chat with him...