Yamaha TZM 150 Riders

[Eyan]

hey bro. yea been quite some time.

 

bz ah bro.. aku keje dah.. korg amacam? btw ride safe brosssssss......

[Eyan]

rinduuuuuuuuuu rinduuuu serinduuuu rinduuuunyeeeeee...

 

lum terserempak kau kat sengkang/punggol lagi lahhh bro hahaha..

 

takper...fate will birng tzmers tgt =x

 

hahahha tu lah blom ada jodih nak jumpe.. tapi 1 hari mesti terserempak.. spore dah lah kecik.. ni lagi sengkang/punggol..

[Eyan]

my meter needle came off when i was speedin inside

CTE tunnel.haha..oooppsss

 

bro cte tunnel plak.. try speeding kat kpe tunnel lerrr.. takyah banyak bawak 90 dah boleh..hehehhe

[karLorenzo]

bro cte tunnel plak.. try speeding kat kpe tunnel lerrr.. takyah banyak bawak 90 dah boleh..hehehhe

 

ouh KPE?tk blh la..last time aku bwk mtr kat sane

da la panas,bwk tkle lebih.haha.klw CTE tunnel le perah...sampai

memekak seluruh tunnel...ape dahh busy sgt...keje mane?

[axr_x]

jb ahboy got full cover set (head, tank, side, tail) for 380rm. taillights at LAB for $10. headlights not sure. should be about same price.

 

bro hancur...

what is the address, i'm pretty new for singapore or malaysia location huehe... sorry because still dumb...

is that original cover or handmade? i want to buy but how to bring it here wekekeke..., i can only take bus, no bike sigh...

 

please give me ahboy's and LAB's address... thanks...

[ben1112]

Hey bros i just have a brilliant idea i wanna share with you guys. Especially those bros with loud pipes. It is an idea to disable the pv with a switch. This will be useful if you get stopped by whoever.

 

The idea is to clutch in and turn on this switch when u see trouble ahead. When u clutch in the revs drop down and the pv automatically closes. Then u flip the switch that is connected in between the servo and controller, it disconnects them and the pv will not open until u turn on the switch.

 

Why do that? because i found out that when i disconnected the pv when it was on the close position, no matter how i rev the bike also sounds very quiet.

 

Maybe before you install the switch u can test. Turn on the key and u will hear the pv check right? 3 sounds. This is clean, close, open. This only occurs the first time after the engine was shut down from a running state. The second time onwards only two sound. Close and open. The first sound is close. Before it can open again u turn the key off. Then locate your pv servo and remove the plug. When u turn on the key again you shouldnt be hearing any sound anymore.. Start engine and rev see if it becomes quieter. If it does, installing a switch inbetween the servo to temporarily disable the servo into a close position might just get you out of trouble one day.

 

This might be useful for some of the bros here.

[Hancur]

bro,kau ada ke jb smlm nye smlm?aku rase aku nmpk

kau kat jb,kau dgn satu penumpang...agaknye uh,,is it?

 

penumpang pompan ke laki? klao penumpang pompan hot tu rider aku la. hahaha.

 

no la. bkn aku. aku tk masuk jb pn. nga tunggu kau ah nie. rabak masuk jb tk ajak. haha.

 

ape la kau nie. asik nmpk org laen pikir psl aku je. rindu pe. turun rumah aku je la klao nk tgk aku. haha.

[Hancur]

hey guys, recently, wanted to try my top speed, whack till 170 den suddenly engine stop, no power, next day went to UniqueMotorsports to service, they said my block gone case, thus causing my piston to jam, had no choice but to choose their $220 top service package, changed piston, piston ring, gasket spark plug etc etc, i want to know where kind i find a place or person that sells a block for tzm that is reasonably priced, unique quoted me $400-500. * heart pain *. any bro's here got any contacts please sms or call me at 98340002, seldom online, my tzm is white/black, 3 stripes, one stretchign to the back, maybe you guys have seen it around =)

 

bro try planet at ubi. i changed my block there. below $300 if i nt wrong. y1. look for the old botak man.

[Boizz]

my meter needle came off when i was speedin inside

CTE tunnel.haha..oooppsss

 

hahahahaah....you fierce la you..haha

 

come sengkang..alot of places to play =x

[Boizz]

hahahha tu lah blom ada jodih nak jumpe.. tapi 1 hari mesti terserempak.. spore dah lah kecik.. ni lagi sengkang/punggol..

 

hahha...aku sokong aku sokong!...aku slalu cuci motor ngan abang hancur @ 247 car park..haha... cam port tak menjadi..lol

[Boizz]

bro try planet at ubi. i changed my block there. below $300 if i nt wrong. y1. look for the old botak man.

 

ceh y1 block..fierce....amacam bro...we race after we go servicing..^^

[shaas_no1]

any bros wanna go in pump petrol tonite ?

i goin arnd 1am. stayin cck

[Boizz]

Hey bros i just have a brilliant idea i wanna share with you guys. Especially those bros with loud pipes. It is an idea to disable the pv with a switch. This will be useful if you get stopped by whoever.

 

The idea is to clutch in and turn on this switch when u see trouble ahead. When u clutch in the revs drop down and the pv automatically closes. Then u flip the switch that is connected in between the servo and controller, it disconnects them and the pv will not open until u turn on the switch.

 

Why do that? because i found out that when i disconnected the pv when it was on the close position, no matter how i rev the bike also sounds very quiet.

 

Maybe before you install the switch u can test. Turn on the key and u will hear the pv check right? 3 sounds. This is clean, close, open. This only occurs the first time after the engine was shut down from a running state. The second time onwards only two sound. Close and open. The first sound is close. Before it can open again u turn the key off. Then locate your pv servo and remove the plug. When u turn on the key again you shouldnt be hearing any sound anymore.. Start engine and rev see if it becomes quieter. If it does, installing a switch inbetween the servo to temporarily disable the servo into a close position might just get you out of trouble one day.

 

This might be useful for some of the bros here.

 

wow..lol..now we can avoid tp...but its ok...i never disturb my pipe...nice tips btw...

 

but eh...TP very sneaky seh...what if before we can press the switch mr TP comes beside you and do this >>>

[karLorenzo]

penumpang pompan ke laki? klao penumpang pompan hot tu rider aku la. hahaha.

 

no la. bkn aku. aku tk masuk jb pn. nga tunggu kau ah nie. rabak masuk jb tk ajak. haha.

 

ape la kau nie. asik nmpk org laen pikir psl aku je. rindu pe. turun rumah aku je la klao nk tgk aku. haha.

 

ouh bkn kau lagi.malu dibuatnya.mtr

kau warnanya popular uh.hah

aku hari tu ke jb amek minyak je.lum dpt gaji.aku

mungkin pergi on the 4th uh.aku free.no work no sch.

sounds goooooood.....uma kau two trafiic lights je.hah

[karLorenzo]

bro hancur...

what is the address, i'm pretty new for singapore or malaysia location huehe... sorry because still dumb...

is that original cover or handmade? i want to buy but how to bring it here wekekeke..., i can only take bus, no bike sigh...

 

please give me ahboy's and LAB's address... thanks...

 

bro,after u bought it...then...

you smuggle it..haha..kiddin..

[karLorenzo]

wow..lol..now we can avoid tp...but its ok...i never disturb my pipe...nice tips btw...

 

but eh...TP very sneaky seh...what if before we can press the switch mr TP comes beside you and do this >>>

 

no need to press anythin....open more

throttle..hahaha

[karLorenzo]

hahahahaah....you fierce la you..haha

 

come sengkang..alot of places to play =x

 

 

yahh lots of str8 roads....

hopefully one day i will test my bike there.hah

[Hancur]

bz ah bro.. aku keje dah.. korg amacam? btw ride safe brosssssss......

 

alamak keje bnyk2 nk bikin mtr lagi pe? atau nk kahwin lagi? haha.

[Hancur]

hahha...aku sokong aku sokong!...aku slalu cuci motor ngan abang hancur @ 247 car park..haha... cam port tak menjadi..lol

 

memang port pe. sape brani masuk? =x

[Hancur]

ceh y1 block..fierce....amacam bro...we race after we go servicing..^^

 

i not fierce. go ask the 'wtf' old man. he changed it lol.

[karLorenzo]

anyone knows an oversize discbrake cost ?

[Hancur]

bro hancur...

what is the address, i'm pretty new for singapore or malaysia location huehe... sorry because still dumb...

is that original cover or handmade? i want to buy but how to bring it here wekekeke..., i can only take bus, no bike sigh...

 

please give me ahboy's and LAB's address... thanks...

 

LAB at kelantan lane off jalan besar.

 

jb ahboy i not sure the address. i think karl should noe the directions. right karl??

[Hancur]

ouh bkn kau lagi.malu dibuatnya.mtr

kau warnanya popular uh.hah

aku hari tu ke jb amek minyak je.lum dpt gaji.aku

mungkin pergi on the 4th uh.aku free.no work no sch.

sounds goooooood.....uma kau two trafiic lights je.hah

 

haha aku da kene tukar display pic ah. skrg bkn color tu lagi.

[Hancur]

no need to press anythin....open more

throttle..hahaha

 

aiya see tp close throttle off engine. no sound at all. haha.

[Hancur]

yahh lots of str8 roads....

hopefully one day i will test my bike there.hah

 

bro when u wanna test, let me know in advance. i inform tp first. haha.