Honda Blackbird CBR1100 XX

[JbAtRaCeR]

Any idea how much does it cost to change the clutch basket? Thks

 

No sure,heard from words of mouth it cost about 300ish...

[blue jellyfish]

For the first yesterday my Handling wobble on the front part @ 140km/h , suddenly so scared to ride above that.. Do u guys think its the alignment?

 

Bro .. u might want to check the tyre air pressure too esp the front one ..

[blue jellyfish]

Other than engine you might want to check on steering cone,swing arm bearings,linkage bearings. For fuel system,you might wanna change your fuel pump filter(which most bikers wont look into),injector wise,if the bike still idle well,no hard starting,smooth throttle response then from my point of view just leave it.

 

Brake system also needs to be looked into,if no leaks on the brake pump and calipers just leave it,you might want to service the sliding caliper mounts as the sliding pins will become dirty and not allow a smooth sliding action when brakes are in use.

 

 

Meni2 thanks again bro .. wa caya sama lu

[hoaxter]

Bro .. u might want to check the tyre air pressure too esp the front one ..

 

Thx bro.... Will take note

[hoaxter]

For the sound on ur clutch area ... Pls check first wif a few mechs first .. My fren whos ridong a 08 busa has the same issue went to few shops and all they said were clutch housing n quoted $400-600... Last he went to shanfu n jawa told him its just tightening of the clutch plates which cost $60 only ^.^ .... so suggest that u guys get it check first b4 wasting some cash

[braveiron]

No sure,heard from words of mouth it cost about 300ish...

 

For the sound on ur clutch area ... Pls check first wif a few mechs first .. My fren whos ridong a 08 busa has the same issue went to few shops and all they said were clutch housing n quoted $400-600... Last he went to shanfu n jawa told him its just tightening of the clutch plates which cost $60 only ^.^ .... so suggest that u guys get it check first b4 wasting some cash

 

Thks for e info guys.

[greysnail]

if u dun wanna hear the clutch basket noise........instal 2bros exzos....confirm cannot hear it anymore.....double confirm.If the noise is disturbing,clutch in la till idle temp is met.

 

racon33 used to ride a bluebird,mebbe the new owner repray it ah.

[MiddleAgedBiker]

Re: the clutch basket noise, don't waste money bro, a few mechs I asked said it's pointless. The noise is quite normal, and even if you change the basket, the noise will come back within 3-4 months. It's not a problem, and it goes away after warming up.

 

Google "Blackbird clutch basket rattle" and you'll get a lot of links telling you essentially the same thing.

[hoaxter]

Anyone got stock monoshock in gd cond to let go cheap cheap or knows where to get 1? Really in need and on tight budget....

[greysnail]

Anyone got stock monoshock in gd cond to let go cheap cheap or knows where to get 1? Really in need and on tight budget....

backtrack the thread,got someone wanna sell his brand new shock.

[Confused]

For the first yesterday my Handling wobble on the front part @ 140km/h , suddenly so scared to ride above that.. Do u guys think its the alignment?

 

Bro this is very serious

I suspect either ure steering cone or wheel bearing is about to give way

This is a Danger sign!!!!!!

Please get it fixed ASAP

[Confused]

For the sound on ur clutch area ... Pls check first wif a few mechs first .. My fren whos ridong a 08 busa has the same issue went to few shops and all they said were clutch housing n quoted $400-600... Last he went to shanfu n jawa told him its just tightening of the clutch plates which cost $60 only ^.^ .... so suggest that u guys get it check first b4 wasting some cash

 

 

The usual cluthch basket sound and the loose screw sounds are very diff

The loose screws will not go away after the engine warms up

it will remain there even at high gears.. worse case scenario the screws come off and break ure clutch cover or go into the engine bits...

No need to say what will happen after that.. Its always best to go to a reputabloe mech to diagnose the problem....

 

BTW alot of people think engine warm up means the engine hot then the noise will disappear

Actually what it means is that the oil has already coated the clutch area (wet clutch mah) thats why the sound goes away

Diff from ducatis and other dry clutch bikes where the noise is always there unless in gear and moving

[Cpt.ZR]

so no one got integrated tailamp for sale?

[rok]

bro, check your wiring and connectors, seems like you having the same problem like me before. Hope this helps...

 

So how do u rectify it bro? Cn u elaborate which wiring must i check or which connectors must i check??? So does this mean that theres nuting wrong with my ECU???

[rok]

Yeap yeap most probably wiring 40% or knock sensor 10% or unknown issue 50%

 

Mine was due to wiring only

 

So hw did you rectify it bro??? Cn you pinpoint me?? Im a newbiw with Blackbird....

[jimmyzee]

So how do u rectify it bro? Cn u elaborate which wiring must i check or which connectors must i check??? So does this mean that theres nuting wrong with my ECU???

 

Bro... Im not good at mechanical advise... but at that time I got 1, 7, 8, 13,14,15,16 blinks at the same time. finally i went down to ah beng from Bikeworkz then he rectify it for me... charges 20SGD...

[rok]

Bro... Im not good at mechanical advise... but at that time I got 1, 7, 8, 13,14,15,16 blinks at the same time. finally i went down to ah beng from Bikeworkz then he rectify it for me... charges 20SGD...

 

where is tis bikeworkz located?

[hoaxter]

Ive changed my cone bearing ... Most probably is tyre pressure as my tyre always drops to 240-250 or the rim bearings maybe i go check it out

[AeROSmitH]

sigh....so no more aftermarket exhaust for the birdie?

[stwb1981]

so no one got integrated tailamp for sale?

 

try ebay mate...

There are plenty of them with diff patterns for u to choose from..

Cheers!!!

if u nid any help juz feel free to pm or sms me...

 

sigh....so no more aftermarket exhaust for the birdie?

 

if hunting 2nd hand u can 4get it mate...

brand new

Scorpion range from $900++ to $1300++

GPR $1350

Remus $1.8k

think tat all for legal mate..

almost all brands i did reaserch liao...

so LL settle for Scorpion...

THE SOUND SUK WITH THE BAFFLES ON!!!!

remove babble is so much better but beware the wrath of TP esp aft GE...lol

[jimmyzee]

sigh....so no more aftermarket exhaust for the birdie?

 

How much you willing to pay for CF End Can Akrapovic x 2 slot in type ( Street legal with cert )

 

where is tis bikeworkz located?

 

Bikeworkz. 157 Kaki Bukit Ave 1. Shun Li Industrial Park Singapore 416013. Tel: 6747 6774. ( look for Ah Beng )

[Trueno]

JImmy don forget wan sell let me know lei ahhahaha i on the que 1st ok ahhaha

a

[whitesugar46]

How much you willing to pay for CF End Can Akrapovic x 2 slot in type ( Street legal with cert )

 

 

Bikeworkz. 157 Kaki Bukit Ave 1. Shun Li Industrial Park Singapore 416013. Tel: 6747 6774. ( look for Ah Beng )

 

Bro Jimmy, selling the Xhaust oredi huh? Not 'garang' enuf huh?

 

 

JImmy don forget wan sell let me know lei ahhahaha i on the que 1st ok ahhaha

a

 

Aiyah!! Was juz bout to contact Jimmy then saw ur msg.....joking oni.....

 

Btw nd an expertise clarification frm the 'Lao Chiao' here.... Is the radiator for Carb model same as the FI model? Thanx in advance 4 e clarification to whoever answer this quest.....

[AeROSmitH]

How much you willing to pay for CF End Can Akrapovic x 2 slot in type ( Street legal with cert )

 

 

 

Bikeworkz. 157 Kaki Bukit Ave 1. Shun Li Industrial Park Singapore 416013. Tel: 6747 6774. ( look for Ah Beng )

 

hi there !!

 

i just got my 05 bb today!

do u have a pic of ur akra?

 

hmm...i was previously riding a vstrom...cant quite get used to the handling of the bb sia~ :~~

[Cpt.ZR]

try ebay mate...

There are plenty of them with diff patterns for u to choose from..

Cheers!!!

if u nid any help juz feel free to pm or sms me...

 

 

haha thanks bro.. cause i see the price is like woooo~~~ haha...

 

anywya i am also new with the birdie... i've taken over zesture's birdy. abig regret is that i should have taken his integrated tailamps.. cause now my rear signals is not very clear.. quite dangerous...