Bike stall after stationery stop. Clutchless bike

[apish88]

I had a problem. I ride an x1 clutchless. Something happen to the bike. While on mainstand, i have no problem engaged to gear 1 2 3 and 4 but once i tap the wheel brake and the wheel stop, the bike dies off. When moving off, tap to gear 1 and bike dies off. Need to throttle to keep the bike moving because once it stops, whole bike dies off. It happen on every gear except neutral. Anyone knows why????

[apish88]

Anyone??? Care to share????

[apish88]

Never happened

Before.......

[apish88]

............

[edwinwu91]

maybe the engine not hot enough? start and put it in idle for 5 min before riding off. if still persist, mechanic is your next best option bro.

[mild_slevin]

perhaps you can check out your clutch system? Its linking engine power to rear wheel.

[OscarMike]

"clutchless" in real world do have clutch, i.e centrifugal clutch will engage at certain rpm but not during idle. seems like urs a bit sticky need to seek mechanic for adjustment or worst case, may require to replace those few pieces clutch plate.

 

btw, most clutch plate are wet type, constantly soak in cylinder oil, plate may get expand over time.

[stsoh]

fuel got water contamination.

drain carb bowl n fuel tank into a container.

then pour back 99% to fuel tank, bottom 1% throw away.

water is heavy will sink to the bottom.

[swashylahs]

that happened to my bike too. but it's because of the wire of the choker. the wire was loose and keep disconnecting from the bike engine, hence everytime i stop, the bike dies off. well, took me about $18 to change the damn wire.