[Discussion] Typical prices for Phantom repairs & mods

[FSbiker]

I think you two are referring to wheel bearing instead...

 

not too sure, for mine the wheel seems okay, but the handle bar seems to be slightly not straight

[dogshit2]

not too sure, for mine the wheel seems okay, but the handle bar seems to be slightly not straight

 

This issue have been with me for quite a while. Went to GNG motors they say handle bar slightly bended.

 

Went to another motorshop in yishun the mech say nothing wrong.

 

When I do a free hand the bike will always tilt to the right.

 

So was planning to do a wheel alignment to set my heart at ease.

 

GnG do wheel alignment at $80.

Wheel bearing its I think $15 per bearing last remembered ah koon told me.

 

But I believe wheel bearing dont cause a bike to tilt to the right. Correct me if am wrong.

[Simmz]

Guys i was juz wondering wud it be possible to install the RXZ belly pan over to my TA200.. Juz like wad most forumers did to their CB400 S4... Has anyone one done it b4?

[mepkoh]

This issue have been with me for quite a while. Went to GNG motors they say handle bar slightly bended.

 

Went to another motorshop in yishun the mech say nothing wrong.

 

When I do a free hand the bike will always tilt to the right.

 

So was planning to do a wheel alignment to set my heart at ease.

 

GnG do wheel alignment at $80.

Wheel bearing its I think $15 per bearing last remembered ah koon told me.

 

But I believe wheel bearing dont cause a bike to tilt to the right. Correct me if am wrong.

wheel alignment??? or folk alignment..sometimes fork is tilted neede to set it straight again..

if bearing on one side is worn out..the result could be what u experienced.

[mepkoh]

Guys i was juz wondering wud it be possible to install the RXZ belly pan over to my TA200.. Juz like wad most forumers did to their CB400 S4... Has anyone one done it b4?

 

some one in pk done it before...not too sure it was a rxk...

[VidaK]

Guys i was juz wondering wud it be possible to install the RXZ belly pan over to my TA200.. Juz like wad most forumers did to their CB400 S4... Has anyone one done it b4?

 

rxz's belly pan is too narrow for super 4... but nvm thats not the point here...

 

sure... why not... anything can be done... just mounting a belly pan... well just need to take note that the ground clearance would be lowered... and with the long wheelbase, you are gonna lose that belly pan in no time... even without a belly pan... the exhaust can be scraped by humps at both 1st and 2nd links if you are not crawling over them...

 

[VidaK]

Repairs / Maintenance :

 

* Fuel Sensor $40 (Planet)custom 4 & above

* Battery $26Yuasa/$38(plug and play) (LAB) / $35 (Planet) / $48 (Ah Koon)/ $60 woodlands road carltex (7Ah battery)

* Steering cone $55-65

* Chain Tensioner $55-60 (for tick tick sound at cold start)

* Front brake disc $45

* Tyres (metz) $150 front & back

* Chain $70-120 depending on type

* Chain + Sprocket - $140+/-

* DID O RING with Original Honda Sprocket - $130 (planet)

* Signal lights - depending on which type you like. $8-25.

* Signal bulb, headlight bulb - 1 $ (LAB, easy DIY) (add on: approved brighter ones for $8. bought from koon.)

* Speedo BackLight + Workmanship (Planet) - S$2

* Headlight - anywhere from $35 to 90 depending the type you like.

* Spark plug - $2-20 [[ Replay once had his changed for S$2 ]]

* Engine oil - $6 -18 (jB got his lousiest EO for $3)

* Brake Pad $15-25

* Bleed and change brake fluid($10 each side)

* Air filter - $10

* Wheel ball bearings - $20-35 (depends on how mech chop u) jtzx: change for only $5 at planet

* Gear Shaft - $100 (planet)

* Clutch plate - $80 (Planet)

* Front fork (1 pair) - $330 (planet)

* Front fork seals (plus fork oil of course) - $65 (planet)

* Front fork tube (1 x) - $30 (planet)

* Rectifier - $75 (planet)

* Coil - $180 (planet)

* Rethreading of spark plug thread - between $35 - $45.

* Gasket - $30 (koon)

* Starter carbon - $60 (planet)

* Front fender - $45 (original honda)

* Rear brake plate w/ pad $58 (planet)

* Rear brake disc - $80 (planet)

* Original rear suspension $180 (planet)

* Repair front brake pump (jam) and replace brake oil -$25 - (planet)

* Replace entire front brake pump ($80) - (planet)

* Rear Brake Pump ($85) (planet)

* Overhaul: Piston+Ring+Block+Top gasket+EO+Plug - ($380) - (planet)

* Rear brake light 12 v 5w/18w $1 (planet)

* Clutch cable - $15 (planet)

* Throttle cable - $12 (planet)

* Front Brake/Clutch Lever - $8 each(planet)

* Balancer [the 2 silver thingies at the edge of your handlebars] - $15 (planet)

* Front fender -$45 (AMK HL motors)

* Spark plug cap - $18 (planet)

 

Mods and Accessories:

* Respray of bike, (front/rear mudguard + Tank) single color - $180 (H L Cycle)

* Wide handlebar (custom4 phantom type) - $38

* Wide Crashbar with mounting points for spotlights - $80

* Footrest - $65-85

- Front\Rubber part - $5/piece @LAB

- Front\Metal base plate - $11/piece @LAB

- Rear\Eagle footrest - $25/pair @ LAB

* Side box e21 - $90-130

* Fuel tank - $382 contact madman or check http://www.pinkphantom.com/estore06.html

* Spotlights $35 a pair http://www.pinkphantom.com/estore11a.html

* Windshield $65-80

* Grips $10-120

* Chrome w/ rubber strips grips (LAB) - $25

* Mirrors $12(LAB) - $50 (jB got his, 8 bucks for small ones)

* Look-alike-original mirrors (shop beside LAB) - $20, LAB should be cheaper.

* Saddlebags $110-180

* Hazard light less than $10 if u fix&wire urself, $18-20 for mech installation [[ S$15 if Replay does it for you! ]]

* Relocating rear signals to license plate - $10 (planet)

* Rear box $80-330

* Voltage stabiliser - $59-$120 depends

* Pillion's 'eagle' footrest w/o installation (LAB) - S$22

* Rider's ORIGINAL footrest (LAB) - S$18 per side, can be cheaper?

* Stainless steel screws for speedo, and side covers. 6 to change altogether. $1-$1.80 also bought from koon.

++ washers to go at 50c each at regina

* Socket for supporting the head light - $15

* Bullet Headlight - $35 (LAB)

* Gear lever with rubber $20 at koon

* Stebel Magnum 2 (Silver) w/o installation - $18-$20 (LAB)

* Daiso electric horns (pair) - $45 (planet)

* Phantom TA 200 gearbox - $540 (planet)

 

Tow Services & Send for Inspection:

 

* Towing (to and fro) - $40 (Planet)

* Send for inspection - $60 (Planet)

[moustache]

I read somewhere that standard servicing costs 25 there..wonder if they have pirelli city demon rear tyre.and how much it'd set me back.also looking to change brake fluids for both front and back..should i buy it first and get them to change..or thy'll just get it for me?how much is it gonna set me back?

[moustache]

?

 

help anyone

[VidaK]

I read somewhere that standard servicing costs 25 there..wonder if they have pirelli city demon rear tyre.and how much it'd set me back.also looking to change brake fluids for both front and back..should i buy it first and get them to change..or thy'll just get it for me?how much is it gonna set me back?

 

hmmm... there is only one person that I know of who goes there... you can try to pm B_E_N...

[qd]

hi, i asking on behalf of my fren.. is there a tankbra for phantom...

 

thanks..

[sh3rman]

from my knowledge no.

[mepkoh]

hi, i asking on behalf of my fren.. is there a tankbra for phantom...

 

thanks..

yeah have...diy type...first buy the brxxxxx

[qd]

yeah have...diy type...first buy the brxxxxx

 

wah... if like dat, must buy lots of it..

[Silent Hunter]

No Bra, only Sexy Bikini!

Phantom got a leather strip to cover the top of the tank, with frills at the side.

Reminds me of the sexy Samba dancer costumes!

[Phantom_maverick]

erm..... where is this H L cycle??

[S750WP]

Can someone post the exact address for Ah Koon?? Need to pay him a visit to charge my batt soon.

[VidaK]

erm..... where is this H L cycle??

 

its at autobay, kaki bukit ave 6... its next to unique

 

Can someone post the exact address for Ah Koon?? Need to pay him a visit to charge my batt soon.

 

blk 61, lengkok bahru road... near red hill mrt...

[armani123sg]

hi guys, anyone knows how much it costs to add the mud flap to the front fender? must drill hole? able to DIY? thanks.

[devil.L]

i got my wide handle bar for a good 80 bucks. did i got con'd? o.o

[VidaK]

i got my wide handle bar for a good 80 bucks. did i got con'd? o.o

 

if that included installation then it isn't so bad

[devil.L]

yea, wrap moutain wrap sea. everything done nicely.. 80bucks. tot i got con'd whn i see th handle bar price at 38sgd here.. lol.

[VidaK]

yea, wrap moutain wrap sea. everything done nicely.. 80bucks. tot i got con'd whn i see th handle bar price at 38sgd here.. lol.

 

well... it depends on what kind of wide handlebar it is... I can say that it is not that abundant nowadays...

[devil.L]

jyea, its th one in my dp.. haha.

[VidaK]

jyea, its th one in my dp.. haha.

 

oh ok... but I can't see it clearly... maybe when I can to see your bike in person I will have a good look...