Yamaha YZF-R6

[Non Stop Racing]

@_@... look above u onceearth. tiuster selling.

 

hanzi finally got ur R ? which shop ya got it from ?

[Luciferwayne]

hi guys .. i looking for R6 . anybody selling can pm mi . thanks lot

 

dun sell ur r6 to this guy here.. haha~!

[Wayang]

Hi guys, is changing the pole light to other colours legal? anyone got caught before for this?

 

wat light u wanna change it into.. disco light ah ?

[dyerfix]

hi guys...when i started my bike...it cranked and the engine started...but the cranking did not stop....i switch off the engine and the cranking still doesn't stop...since i can;t do anything...i just rode normally and it eventually stop...happened on 2 occasions already...anyone experience b4?

[hanzi24]

@_@... look above u onceearth. tiuster selling.

 

hanzi finally got ur R ? which shop ya got it from ?

 

Eh, u know me meh? ya got it last week from bike production...

[hanzi24]

wat light u wanna change it into.. disco light ah ?

 

wah lau what disco light... lol... just thinking of changing to blue, red or green those colours that pple normally change...

[AR2 Performance]

wah lau what disco light... lol... just thinking of changing to blue, red or green those colours that pple normally change...

 

 

Change/darken/cover/partial cover of pole lights, main light, tail light & signal lamps to any other color is considered not legal. It is considered as "mis-leading" to other road users.

[hanzi24]

omg... i have tried 3 tanks of petrol that my bike is running in now... the fuel consumption now is like 14km/l, 14km/l, 15km/l... is running in suppose to have higher fuel consumption??? Travelling below 5k rpm every gear...

[fruitcakepablohoney]

Muffler Slider

 

MUFFLER SLIDER

 

Before Crash

 

http://i72.photobucket.com/albums/i177/luthertoh/de0b_1_sbl.jpg

 

After 60-65 MPH Low side!

 

Customer said if he had mounted the slider in tiop of the rivets there would have been zero damage.

 

http://i72.photobucket.com/albums/i177/luthertoh/91a5_1_sbl-1.jpg

 

http://i72.photobucket.com/albums/i177/luthertoh/8461_1_sbl.jpg

 

Some bikes need more than 1 Muffler Sliders to fully protect your muffler.......... 1 at the front and 1 at the back.

 

http://i72.photobucket.com/albums/i177/luthertoh/38_1_sbl.jpg

 

Colors available are Red, Blue, Orange, Yellow & Black.

 

http://i72.photobucket.com/albums/i177/luthertoh/6e22_1_sbl.jpg

 

Muffler Slider sizing chart

 

Mini Slider Fits - 10-12 inch circumference muffler

 

Small 1/2 Slider Fits - 12-14 1/2 inch circumference muffler

 

Full Slider Fits - 12- 14 1/2 inch circumference muffler

 

Full XL Slider Fits - 14 1/2 - 22 inch circumference muffler

 

To determine proper Muffler Slider size needed - using a fabric Sewing tape measure or a piece of string, measure the circumference of your muffler by wrapping around your desired Muffler Slider location as shown below.

 

http://i72.photobucket.com/albums/i177/luthertoh/b1f9_1_bl.jpg

 

Est price not more than $99 Sing dollar (will be cheaper depanding on how many orders)

 

Add your nick on the list if you like to get one.

 

Nick/Contact No. /Colour/Muffler Slider sizing/Qty

1. R46/98732551/black/Full XL Slider/2

2. fruitcakepablohoney/black/Full XL Slider/1

3. rein_jahat14/black/Full XL Slider/1

4. snakeman/black/full XL Slider/1

5.

6.

7.

8.

9.

10.

 

PLS TAKE NOTED I HAVE CHANGE THE PRICE TO $99 .

[wait4me]

hi guys

rebuilt radiator better or buy back stock better??

[ambasnakeman]

rebulit radiator is good enough....but if doing track riding, stock is better

[AR2 Performance]

omg... i have tried 3 tanks of petrol that my bike is running in now... the fuel consumption now is like 14km/l, 14km/l, 15km/l... is running in suppose to have higher fuel consumption??? Travelling below 5k rpm every gear...

 

Running in tends to have lower fuel consumption generally. Because many do not ride at the usual pace/pick up/throttle response. Most bikes have an optimal cruising speed, at top gear, which in turns gives u a cruising rpm. I did a hard run-in, and rode like normal. I have had 16.5km/l constant right from the 100km mark, to the now 20,000km mark. Thats approximately with very brisk pick up to 70~100kmh as much as possible, along with at least 90% freeway riding & octane97 Petronas.

 

Some variables to consider when check fuel consumption. Varies alot with rider/how he rides, nature of traffic etc.

 

1. How did you get to 100kmh? slowly slowly low rpms? hard accel but reach 100kmh fast and stay there?

 

2. start stop lights? freeway riding? Slow down & accel alot in freeway but bad traffic?

 

3. type of petrol?

[hanzi24]

Running in tends to have lower fuel consumption generally. Because many do not ride at the usual pace/pick up/throttle response. Most bikes have an optimal cruising speed, at top gear, which in turns gives u a cruising rpm. I did a hard run-in, and rode like normal. I have had 16.5km/l constant right from the 100km mark, to the now 20,000km mark. Thats approximately with very brisk pick up to 70~100kmh as much as possible, along with at least 90% freeway riding & octane97 Petronas.

 

Some variables to consider when check fuel consumption. Varies alot with rider/how he rides, nature of traffic etc.

 

1. How did you get to 100kmh? slowly slowly low rpms? hard accel but reach 100kmh fast and stay there?

 

2. start stop lights? freeway riding? Slow down & accel alot in freeway but bad traffic?

 

3. type of petrol?

 

 

gradual acceleration leh, never whack cos still running in... half the time small road seldom jam half on expressway... normally at 90+km/h and stay there... tried 98 and 95 not much diff, 98 sightly better

[AR2 Performance]

gradual acceleration leh, never whack cos still running in... half the time small road seldom jam half on expressway... normally at 90+km/h and stay there... tried 98 and 95 not much diff, 98 sightly better

 

I believe the definition of gradual & whack varies subjectively. Give it sometime...

[hanzi24]

I believe the definition of gradual & whack varies subjectively. Give it sometime...

 

ok... will see how it goes after run in...

[Wayang]

Eh, u know me meh? ya got it last week from bike production...

 

hows the bike so far ? hot anot ? lolz

[Apoc]

Its bloody hot lah. After he gets off the bike, ill hop on to it and once kinda burnt my knee when it touched the main frame.

[hanzi24]

hows the bike so far ? hot anot ? lolz

 

It's a "HOT" bike in every aspect... lol

[wait4me]

rebulit radiator is good enough....but if doing track riding, stock is better

 

ic.

cause already kana stock le

on my rebuilt ,

so thinking i should get rebuilt again or get a stock wan

and yes i have the radiator mesh ..

but haiz ,.. accidents happen

a stone hit my top right hand side of the radiator

[Wayang]

It's a "HOT" bike in every aspect... lol

 

shiok right.. hahaha.. anyway u'll get used to it.. other tat or ur lower body is half cooked so u cant feel a thing..

[hanzi24]

Anyone place their IU below the back sit of a 06/07? Can it fit in and is it detectable when passing the ERP gantry?

[TiUsTer]

Anyone place their IU below the back sit of a 06/07? Can it fit in and is it detectable when passing the ERP gantry?

 

u wont b able to fit it it there unless u remove the bar that locks the rear seat. i had a race tail b4 n remove that bar, place my IU in there n had no probs detecting it when going thru gantry.

[Chubb]

Anyone place their IU below the back sit of a 06/07? Can it fit in and is it detectable when passing the ERP gantry?

 

mine in my back seat.. another way of not removing e bar is do some cutting off from yr IU.

wat to cut? dat depends on u.

its stil detectable on slow speed.. fast speed depends

[hanzi24]

u wont b able to fit it it there unless u remove the bar that locks the rear seat. i had a race tail b4 n remove that bar, place my IU in there n had no probs detecting it when going thru gantry.

 

Remove the bar then how to lock the seat? or do u mean remove the bar, place the IU then put the bar back?

[R46]

MUFFLER SLIDER

 

Before Crash

 

http://i72.photobucket.com/albums/i177/luthertoh/de0b_1_sbl.jpg

 

After 60-65 MPH Low side!

 

Customer said if he had mounted the slider in tiop of the rivets there would have been zero damage.

 

http://i72.photobucket.com/albums/i177/luthertoh/91a5_1_sbl-1.jpg

 

http://i72.photobucket.com/albums/i177/luthertoh/8461_1_sbl.jpg

 

Some bikes need more than 1 Muffler Sliders to fully protect your muffler.......... 1 at the front and 1 at the back.

 

Colors available are Red, Blue, Orange, Yellow & Black.

 

http://i72.photobucket.com/albums/i177/luthertoh/6e22_1_sbl.jpg

 

Muffler Slider sizing chart

 

Mini Slider Fits - 10-12 inch circumference muffler

 

Small 1/2 Slider Fits - 12-14 1/2 inch circumference muffler

 

Full Slider Fits - 12- 14 1/2 inch circumference muffler

 

Full XL Slider Fits - 14 1/2 - 22 inch circumference muffler

 

To determine proper Muffler Slider size needed - using a fabric Sewing tape measure or a piece of string, measure the circumference of your muffler by wrapping around your desired Muffler Slider location as shown below.

 

http://i72.photobucket.com/albums/i177/luthertoh/b1f9_1_bl.jpg

 

Est price not more than $99 Sing dollar (will be cheaper depanding on how many orders)

 

Add your nick on the list if you like to get one.

 

Nick/Contact No. /Colour/Muffler Slider sizing/Qty

1. R46/98732551/black/Full XL Slider/2

2. fruitcakepablohoney/black/Full XL slider/1

3. rein_jahat14/black/Full XL slider/1

4. snakeman/black/full XL Slider/1

5.

6.

7.

8.

9.

10.

 

PLS TAKE NOTED I HAVE CHANGE THE PRICE TO $99 .

CLOSING DATE OF ORDER 31/10/07 .

PAYMENT TO BE MAKE ON 1/11/07