need your help guys

[namso354]

hi there,..

 

just need to ask a question,...

 

whenever i switch on my signal light on my spr 4, the headlight's light seems to go in and out, why is this so??

 

any help??

[zax]

hi there,..

 

just need to ask a question,...

 

whenever i switch on my signal light on my spr 4, the headlight's light seems to go in and out, why is this so??

 

any help??

 

huh wat u mean by in and out>>

[Ah Pek]

in and out

 

Like those exotic sport car with flip head lamp like dat lah....

[zax]

Like those exotic sport car with flip head lamp like dat lah....

 

wa new kind of headlight ah.. nice le.. buy from ah boy is it?

[namso354]

i mean, when u on yr signal, the headlight seems to loose power la,..the light go in n out when the signal light flickers

[casiolover]

i mean, when u on yr signal, the headlight seems to loose power la,..the light go in n out when the signal light flickers

 

Its normal ... when you rev till 2-3.5k rpm or above 6k rpm it doesn't .. cos its charging the battery... idle rpm just normal charge only...will flicker

[Ah Pek]

when u on yr signal, the headlight seems to loose power la,..the light go in n out when the signal light flickers

 

Not sure how old is your bike but this is definitely bad common grounding. There is insufficient power supply to substain your head lamb when the signal light uses it. Also your battery can be weak or rectifier not charging up to spec/rate. The best soloution is to do a proper grounding to your bike and see if it helps. Good luck.

[namso354]

where can i go do the grounding??

[nando]

ya ah.. where can i do grounding??

[kurarensu]

grounding there's many places you can do.. at below $70 for 3-5pts grounding.. you can check out the thread on PowerAbuser @ the advertiser thread.. they have grounding services as well..

 

btw i spotted a mistake.. "... head lamb ..." hees..

[FunkyChicken]

did you use after market signal light?? if yes check the correct rating of the bulb ampere.

 

if dats not the problem grounding or new batt and rect will do the trick.