[Discussion] Super Four General Enquiry Thread

[helmichua]

Bro, dis one still available? inspection can pass? how much?

[helmichua]

Still available? how much?

[c4traz]

Any source for 2nd spare parts?

Looking for headlight for my super4 project big one '96

[tanyk35]

Bro,

 

Currently i have lost my Bike Key and i do not have any Spare Key with me.

 

Can anyone advise of the cost for the replacement key and where can i do it.

Thanks.

[thrasher]

if you're still paying by installments, i think the bikeshop holding your original key.

[tanyk35]

Bro,

 

my bike is an 2nd hand bike and the bike shop do not have any spare key.

[tiku]

alamak big prob... lost key = cannot start bike=cannot open seat=cannot open fuel cap... how unique duplicate key rrequires to strip the bike so need to take out seat and tank... call unique is u wan fast answer

[manbai]

As far as I know, if no key at all must change whole ignition system. Jia lat liao.

[danielling1981]

Can try contact e previous owner and search all e way to 1st owner. Find out when 1st hand buy from where and check with e shop.

 

If cant find master key then

[captain_des]

no need to change whole ignition

 

just go boon siew, bike production or mah to check they can do it.

 

a new key would be very costly since there's a programmable chip in the key

 

take your log card down with ic they can do (engine and chassis number required with proof of ownership)

 

some bike shops even told me they have to ship in from japan (what a freaking joke? think i p plater si bo?)

Edited May 17, 2012 by captain_des

[nightsteed]

As far as I know, if no key at all must change whole ignition system. Jia lat liao.

That what i heard from my mech too, told me die die must keep spare key or else the cdi need to change... cost around 500.

[danielling1981]

Wat i understand is spare key cant be used for duplication of extra keys. Only master key can. Which is y e owner's manual will state tat u should not use e master key.

 

If master key lost need to change something. Change wat i dunno but sounds like not cheap.

[manbai]

That what i heard from my mech too, told me die die must keep spare key or else the cdi need to change... cost around 500.

 

I kena b4, chip in key spoilt n got no spare. $700 burnt on a slighly new ignition n cdi.

So now use spare n keep original key for emergency.

[nightsteed]

I kena b4, chip in key spoilt n got no spare. $700 burnt on a slighly new ignition n cdi.

So now use spare n keep original key for emergency.

My mech also suggest swapping the keys (use the spare for sometime, then swap to using original) to keep both functional... if one key too long never use, might have problem starting the bike.

[tiku]

Anyone know how to identify if hisskey is master or spare? Or do they look alike?

[stwb1981]

any good shop or mechanic that you guys can recommend? bike had a stationary drop on the right side a few months back.

 

my spec1 meter started with RPM meter cannot work, then progressed to Speedo, now fuel bar and time cannot see liao.

 

checked at FJT with regards to the pricing and was quoted about $800 for whole meter but they did ask which part of the meter could not work which I'm not really sure. To save hassle might as well go to a good shop whom is experienced with this problem.

 

Thanks in advance yah

 

There are quite a handful of oem meter online fr China...

I juz gt myself a PB1 hence sourcing for parts & accessories...

Anything juz drop me a pm & I see if my regualr supplier have it or nt...

Confirm cheaper than getting original..lol

 

Hey guys, anyone know of a trusted online website that sells super 4 parts and accessories?

 

Try ebay motor & type cb400 & the model...

U gt alot of filtering to do as it has many years of cb400 & some U nv see oso..lol

Try quite a few stuff are available...

 

Cheers!!!

[babyjuniorx]

Where can I get a dyno jet and dyno run other then hkl? Please pls pm me !

[stwb1981]

Where can I get a dyno jet and dyno run other then hkl? Please pls pm me !

 

Racewerks.....

[FirmanWahab]

My head gasket area is leaking with engine oil, not much, just minimal, near the area of the cylinder head.

 

I understand it's in between the cylinder head and engine block.

 

Must the coolant be flush too where doing this servicing?

 

Is it time to change the gasket? How much will it be to replace?

 

Hope to hear from you. thanks!

[babyjuniorx]

I have just change after market exhaust,

 

Do I need to tune and wash carb or just tune? Please advice. For now it's working fine though .

[Ah Pek]

I have just change after market exhaust,

 

Do I need to tune and wash carb or just tune? Please advice. For now it's working fine though .

 

You pm me this morning and had my answers and now asking here somemore. Hmmm...don't trust what I said iszit? Please next time don't waste my time...asked here first!

[itom32]

[Q]Hi

Doe's anyone knows where I can find a bellypan like this?

http://i1044.photobucket.com/albums/b446/itom32/cb400sf5.jpg

http://i1044.photobucket.com/albums/b446/itom32/undercowl1.jpg

I live in Europe and i can not find something.

Edited May 25, 2012 by itom32

[Ah Jeff]

Hi Guys,

 

I need advices. I'm looking for 2nd hand Super 4. Today I went down to workshop & was offer at:

 

1) Machine Price: $7,800

2) Spec: Spec 1 (FS plate, renew COE left 8yrs)

3) Downpayment: $900 inclusive of insurance, road tax etc

4) Monthly Instalment: $280

5) Repayment Period: 3 years

 

Guys, Please advise if the bike is worthy of the price? I have been away from "Bike world" for few years which is y i need advice from u guys.

 

PS: The body work & engine condition not bad.

[y2kredbull]

Morning All.Does Auntie Shop's tank bra able to be customised with bagster mounting points?

[y2kredbull]

Hi Guys,

 

I need advices. I'm looking for 2nd hand Super 4. Today I went down to workshop & was offer at:

 

1) Machine Price: $7,800

2) Spec: Spec 1 (FS plate, renew COE left 8yrs)

3) Downpayment: $900 inclusive of insurance, road tax etc

4) Monthly Instalment: $280

5) Repayment Period: 3 years

 

Guys, Please advise if the bike is worthy of the price? I have been away from "Bike world" for few years which is y i need advice from u guys.

 

PS: The body work & engine condition not bad.

 

Bro,the machine price quite ex for spec1 which i assume is ur model.Unless the bike got accesorries.Cos i jus got mine machine $6.2k.Stock machine coe till feb 2020.