[Discussion] Super Four General Enquiry Thread

[Ah Pek]

Wah me too looking for speedo to change..ah pek any idea whether can fit other spec versions speedo on spec2? Or must reali find Spec 2 speedo to replace?

 

 

Sent from my iTouch using Tapatalk

 

Likely not as the start switch and left side headlamp switch assemblies has different wiring to the meter set of wiring. Further more..the meter sitting mount is likely different. There are other equipment from 3rd party product I seen before that comes with clock, speedometer, temperature, rpm meter...etc..in hi-tec design digital type. Can use that as an option..about $300+ or so. Just added mount to your handle bar. I think MotorWorld has it..not sure.

[aminnurasyid]

Wah..thanks for ur reply ah pek.

Didnt know its that complicated..

Have check around n see some spec 2 the numbering on speedo is red not white. Some say white is OEM..bt hardly I saw white numberings on spec2 speedo..isit Bcoz the speedo easily spoilt n has been changed to aftermarket speedo..real lost..

 

 

Sent from my iTouch using Tapatalk

[jimmmmmy]

Hi bros, have you guys ever encounter the fuel meter running from center to both sides? i know if it hits reserve the meter will go from right to left. but mine is from center. like this >>>

[Iceachilles]

Hi bros, have you guys ever encounter the fuel meter running from center to both sides? i know if it hits reserve the meter will go from right to left. but mine is from center. like this >>>

 

There is a Connector (dunno is it called a fuel sensor) right side under your tank for vtec models which nvr connect

[jimmmmmy]

found the connector alr. thanks a lot!

[army_ncc]

Hi bro and sis

 

like to know where i can change the lcd panel for the fuel and mileage lcd panel. have went through a few threads but there were no concrete workshop mention. mine is a super 4 spec 2, many thanks.

 

Go bikeworkz. I did mine last year.

[army_ncc]

Hey guys, my speedo meter sometime working but sometime not working. When it's not working, my trip meter also never move. Is it my speedo sensor spoil? If so, how much does it cost to get it replace? Thanks guys!

[pass123]

Hey guys, my speedo meter sometime working but sometime not working. When it's not working, my trip meter also never move. Is it my speedo sensor spoil? If so, how much does it cost to get it replace? Thanks guys!

 

hi, have the same problem. sometime on sometime off on the road but didnt notice the trip meter. didnt really go and find out whats the problem, think most rider can estimate the speed. after all dont really look at meter every time. if u find out whats the problem, can inform me. mine is spec 1 fu plate. thanks

[Ah Pek]

Hey guys, my speedo meter sometime working but sometime not working. When it's not working, my trip meter also never move. Is it my speedo sensor spoil? If so, how much does it cost to get it replace? Thanks guys!

 

Does ur bike jerks or felt kind of like under power oso?

[pass123]

Does ur bike jerks or felt kind of like under power oso?

 

Hi, my bike no power lost. It run like normal only the meter problem on and off. Any idea

What's the problem.thanks

[Ah Pek]

Hi, my bike no power lost. It run like normal only the meter problem on and off. Any idea

What's the problem.thanks

 

Yes..could be meter sensor problem.

[devilprinz]

Hi every1, yesterday top-up my coolant.

 

Hands shaky till spill here and there wasted coolant abit ... thats okay but i over shot the coolant in the reserve reservoir upper level by one inch.

 

My question is, would it have any ill effects when the coolant is top-up beyond the upper level marker?

 

Thank you

[Ah Pek]

Hi every1, yesterday top-up my coolant.

 

Hands shaky till spill here and there wasted coolant abit ... thats okay but i over shot the coolant in the reserve reservoir upper level by one inch.

 

My question is, would it have any ill effects when the coolant is top-up beyond the upper level marker?

 

Thank you

 

Its ok lah..just that somemore will overflow thru the overflow excess tube and u see some coolant at below center of the bike on the floor area when u park...evetually, the level will stablise.

[devilprinz]

Its ok lah..just that somemore will overflow thru the overflow excess tube and u see some coolant at below center of the bike on the floor area when u park...evetually, the level will stablise.

 

Thank you so much for your reply Mr. Ah Pek ~~

 

Very helpful & informative as usual

 

Cheers

[pass123]

Yes..could be meter sensor problem.

 

Thanks for the advise, by the way do u know where is the speed sensor located? Think of

Taking out to clean, thanks.

[Ah Pek]

Thanks for the advise, by the way do u know where is the speed sensor located? Think of

Taking out to clean, thanks.

 

If its the sensor u are sure of..it has to be replaced. I believe its located in the mid section of the gearbox top area..haven't really done it myself but ur carbs all have to come off..its not a "ABC" thing to do. I have one more question...is ur RPM meter affected when the problem comes..like sluggish movement at certain rpm?

[pass123]

If its the sensor u are sure of..it has to be replaced. I believe its located in the mid section of the gearbox top area..haven't really done it myself but ur carbs all have to come off..its not a "ABC" thing to do. I have one more question...is ur RPM meter affected when the problem comes..like sluggish movement at certain rpm?

All is ok, except the speedometer on,off. Most likely is the sensor or wiring problem.

Thanks for ur help.

[pass123]

Hi Guys,

 

I recently bought a Spec3.When i Switch on the bike it runs both the meters ( Speedo & Rpm ),. But when i ride the bike the speedo meter is not working & the rpm is working just fine.So just because of that mileage also not working .Since cables are not available in this model what could be the problem ? Since the meters are working when switch on can't be a meter problem ! Please help me on this

 

Hi, ur problem solved? Is it the sensor problem and where is located, thanks. Having the same problem.

[lycan]

I am currently riding a spec1 with its original tail brakelight.

 

Is it possible for me to replace the fluorescent bulbs to LED bulbs?

 

If yes, which model should I quote when purchasing?

 

Thanks

 

Sent from his Galaxy Tab 8.9

[edwardthy]

I am currently riding a spec1 with its original tail brakelight.

 

Is it possible for me to replace the fluorescent bulbs to LED bulbs?

 

If yes, which model should I quote when purchasing?

 

Thanks

 

Sent from his Galaxy Tab 8.9

 

bro why do you need to replace with LED? As far as i recommend, its best to stick with stock for your lightings as LED etc is not stock and you can get fined or wont pass inspection.

[pass123]

If its the sensor u are sure of..it has to be replaced. I believe its located in the mid section of the gearbox top area..haven't really done it myself but ur carbs all have to come off..its not a "ABC" thing to do. I have one more question...is ur RPM meter affected when the problem comes..like sluggish movement at certain rpm?

Hi, just to update. Sensor change and everything is fine. Thanks for the reply. Saw u been advising

Members, actually what service u provide? Maybe can try some of ur service. Thanks

[Ah Pek]

Hi, just to update. Sensor change and everything is fine. Thanks for the reply. Saw u been advising

Members, actually what service u provide? Maybe can try some of ur service. Thanks

 

Talk kock...sing song all about bikes and over coffee services...ha....x3! Ride safe bro!

[ducktale83]

I am currently riding a spec1 with its original tail brakelight.

 

Is it possible for me to replace the fluorescent bulbs to LED bulbs?

 

If yes, which model should I quote when purchasing?

 

Thanks

 

Sent from his Galaxy Tab 8.9

 

Just make sure its red led bulb..can buy frm m400 frm mass order:)

[joe1234]

Hello any bros here can advise me where to get the 2 x side box with bracket to fit on vtec 2 probably the estimated pricing.

[lycan]

Just make sure its red led bulb..can buy frm m400 frm mass order:)

 

I am getting white. I am riding a spec 1. The rear brake light is used to illuminate the license plate too. If i were to use red, i dont think is it bright enough.. :\

 

on a side note, M400 sold out the brake light LEDs.

 

Hello any bros here can advise me where to get the 2 x side box with bracket to fit on vtec 2 probably the estimated pricing.

 

E21 with SB2000 rack is about 210-220 from LAB before bargain. :\